GameMax F46 ATX Gaming Case User Manual
Package Contents
Item Identifier | Quantity | Description |
---|---|---|
A | 14 | MB Screw |
B | 4 | PSU Screw |
C | 8 | 3.5" HDD Screws |
D | 8 | 2.5" SSD Screws |
E | 14 | Hard Drive Damper |
F | 1 | Hex Wrench |
G | 5 | Motherboard Standoff |
H | 6 | Cable Tie |
Connectors and I/O Panel
The case features several connectors for motherboard and front panel I/O:
- Combo Audio: For audio connections.
- POWER SW: Power switch connector.
- USB 3.0: High-speed USB ports.
- Type C Gen2: Next-generation USB Type-C port.
The I/O panel on the front typically includes:
- USB 3.0 ports
- Type-C Gen2 port
- Combo Audio jack
- Power SW button
Exploded View Components
The following components are identified in the exploded view diagram:
- Front Panel
- Left side panel
- Right side panel
- Chassis
- Detachable bottom plate
- GPU Card Holder
- IO Component
- LOGO Component
- Front 120mm fan (x3 included)
- Rear 120mm fan (x1 included)
Installation Guide
-
Panel Removal
Remove the left and right side panels and the bottom plate.
Remove the front panel. Note: If a fan is pre-installed in the front, the panel does not need to be removed.
-
PSU Installation
Insert the PSU from the right side and secure it with screws.
-
Motherboard Installation
Install the motherboard. Place the I/O baffle and secure it with screws.
-
PCI-E Slot Installation
Open the magnetic PCI-E baffle. Remove the PCI-E interface card, insert it into the graphics card slot, and lock the screw fixation.
-
Drive Installation
Install 3.5" HDDs and 2.5" SSDs using the provided screws. Some installations may use lock-free screws.
-
Fan Clearance Note
If a 3.5-inch HDD is installed at the bottom, only two 120mm fans or one 140mm fan can be installed in the front.
-
I/O and LOGO Component Placement
The I/O component can exchange positions with the LOGO component for flexible front panel configuration.
Cooling System Support
Fan Cooling System:
- Front: 3x120mm (included), 2x140mm (included)
- Bottom: 3x120mm / 2x140mm (optional)
- Rear: 1x120mm (included)
Liquid Cooling System:
- Front: 120/240/280/360mm (optional)
- Rear: 120mm (optional)
Airflow Direction
Pay attention to the airflow direction inside the chassis for optimal cooling performance.