Ninebot KickScooter F Series

Product Overview

The manufacturer reserves the right to make changes to the product, release firmware updates, and update this manual at any time. Visit www.segway.com or check the Segway-Ninebot app to download the latest user materials. You must install the app, activate your KickScooter, and obtain the latest updates and safety instructions.

The pictures shown are for illustration purposes only. The actual product may vary.

1 Diagram

Handlebar: Contains the electric throttle, bell, brake lever, and headlight.

Dashboard & Power Button: Displays speed, battery level, Bluetooth connection, and error notifications. The power button turns the scooter on/off and controls the lights and speed modes.

Stem: Connects the handlebar to the main body of the scooter.

Snap Hook: Used for folding the scooter.

Quick-release lever: Facilitates folding and unfolding.

Folding Mechanism & Safety Hook: Secures the scooter when folded.

Front Fork & Front Fender: Houses the front wheel and protects from debris.

Hub Motor: Provides power to the scooter.

Footboard: Where the rider stands.

Buckle: Part of the folding mechanism.

Rear Fender: Protects from debris kicked up by the rear wheel.

Rear Light: For visibility and signaling.

Disc Brake: Provides braking power.

Battery Compartment: Houses the battery.

Kickstand: Allows the scooter to stand upright when not in use.

Charge Port: For connecting the charger.

Dashboard & Power Button Details

Speedometer: Displays current speed (km/h or mph) and error codes.

Bluetooth: Indicates connection to a mobile device.

Headlight: Controls the front and rear lights.

Temperature Warning: Illuminates if the battery temperature is too high or too low.

Power Button: Press to turn on; press and hold for 3 seconds to turn off. Press once to toggle lights, press twice to switch speed modes.

Speed Mode: Three modes are available: ECO (Energy-saving), D (Standard), and S (Sport). Top speeds vary by model.

Error Notification: An icon (e.g., a wrench ?) indicates an error.

Battery Level: Indicated by bars; a red bar signifies low battery.

Specifications

[1] Typical Range: tested while riding under full power, 165 lbs (75 kg) load, 77°F (25°C), 60% of max. speed on average on pavement. Some factors affecting range include speed, number of starts and stops, ambient temperature, etc.

3 Certifications

This product is certified to ANSI/CAN/UL-2272 by TUV Rheinland.

The battery complies with UN/DOT 38.3.

The battery complies with ANSI/CAN/UL-2271.

Federal Communications Commission (FCC) Compliance Statement for USA

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.

Industry Canada (IC) Compliance Statement for Canada

This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.

CAN ICES-3 (B)/NMB-3(B)

Neither Segway Inc. nor Ninebot is responsible for any changes or modifications not expressly approved by Segway Inc. or Ninebot. Such modifications could void the user's authority to operate the equipment.

Model: F25/F30/F30S/F40

FCC ID: 2ALS8-KS0005

IC: 22636-KS0005