LED's light Solar Path Lighting Puck - RGB

Product Features

• LED Type: [LED]
• Color: RGB [RGB]
• Lifespan: 10,000 hours
• Brightness: 1 Lumen
• Sensor: Yes [SENSOR]
• Light Color Temperature: Warm White 2700K
• Operating Temperature: -8°C to 45°C [Temperature]
• Dimensions: Length 45mm, Diameter 105mm [Length] [Diameter]
• Beam Angle: 180°
• Dimmable: Non-Dimmable
• Power Consumption: 0.045 Watt
• Weight: 143g [Weight]
• Battery: 1 x Ni-MH 1.2V 500mAh 0.6Wh [Battery Type] [Capacity] [Energy]
• Runtime: 6-8 hours [Hours]
• Included: Yes
• Ingress Protection: IP44 [IP Rating]
• Electrical Class: Class III [Electrical Class]
• Usage: Outdoor

Introduction

Please read this instruction manual carefully before use.

Initial Charging

If the solar panel is covered with a thin protective film, remove it before using the product.

Step 1: Remove the ground spike by holding the solar unit firmly and turning the ground spike counter-clockwise, as shown in Figure 1. Remove the pull-tab from the battery compartment.

Step 2: Replace the ground spike, and turn it clockwise to lock it (Figure 2).

Place the product in a location where it can receive a full 8 hours of sunlight to allow the rechargeable battery to reach maximum capacity.

Optimal Location for Charging

Place the product in an area where it can receive direct sunlight for at least 8 hours each day. Shadowed locations will not allow the battery to charge fully and will reduce the hours of nighttime lighting.

The selected location should not be near nighttime light sources, such as porch lights, street lights, or pool lights, as these may cause the solar light to turn off prematurely.

Operation

This product has two distinct modes of operation, selectable by means of the mode switch (A).

The mode switch has three positions:

• OFF: Turns the device off; it will not light at all.
• ON: When darkness falls, the product will start to spread a warm white light (2700K).
• RGB: When darkness falls, the product will start to slowly phase through all the colors of the rainbow, gently flowing from one to the other.

When fully charged, the product will light up for 6-8 hours.

Battery Replacement

NOTE: This operation should be done in the morning on a sunny day. This will allow the product to receive a full 8 hours of sunlight so that the rechargeable battery can reach maximum capacity.

1. Remove the ground spike by turning it counter-clockwise (Figure 1).
2. Remove the old battery and replace with a new AAA size 1.2V rechargeable battery of same or greater capacity (mAh). (USE RECHARGEABLE Ni-MH (HR03) BATTERIES ONLY!)
3. Clean the battery contacts and those of the device prior to battery installation.
4. Be sure to insert the battery in the proper direction (+/-).
5. Replace the ground spike on the solar puck (Figure 2).

Warnings

• Safe for outdoor operation.
• ⚠️ Failure to insert battery in the correct polarity, as indicated in the battery compartment, may shorten the life of the battery or cause battery to explode or leak.
• Do not dispose of batteries in fire.
• Batteries should be recycled or disposed of as per manufacturer's recommendations.
• Remove battery if consumed or if product is to be left unused for a long period.

Care and Cleaning

The solar panel should be cleaned periodically with a damp cloth for maintaining optimum performance (to remove dust and debris).

Do not place in areas where children normally play, or where they may trip and fall against the solar lantern.

Safety Information

General Safety

• Read the manual carefully before use. Keep this manual for future reference.
• Only use the product for its intended purposes. Do not use the product for other purposes than described in the manual.
• Do not use this product if any part is damaged or defective. If the product is damaged or defective, replace the product immediately.
• This product shall not be used by children without the supervision of an adult. Children shall not play with the device.
• Do not modify the product in any way.
• Do not expose the product to water or moisture. (IP 20)
• Do not immerse the product into water. (IP 44 – IP 67)
• Keep the product away from heat sources.
• Do not block the ventilation openings.
• Do not look directly into the LED lamp.
• Keep a minimum distance of 1 meter between the lamp and the surface being illuminated.

Electrical Safety

• To reduce risk of electric shock, this product should only be opened by an authorized technician when service is required.
• Do not use the product if the cable or plug is damaged or defective. When damaged or defective, it must be replaced by the manufacturer or an authorised repair agent.
• Before use, always make sure that the voltage is the same as the voltage on the rating plate of the device.
• Make sure that the cable does not hang over the edge of a worktop and cannot be caught accidentally or tripped over.

Warnings

• The light source contained in this luminaire shall only be replaced by the manufacturer or his service agent or a similar qualified person.
• ? Caution, risk of electric shock.
• The external flexible cable or cord of this luminaire cannot be replaced; if the cord is damaged, the luminaire has to be destroyed.

Disposal

GB Notes on Disposal: The product is designated for separate collection at an appropriate collection point. Do not dispose of the product with household waste. For more information, contact the retailer or the local authority responsible for waste management.

WEEE Information: NL: 3505, DE: 37281017, AT: 40133, ES: 7020

Documentation and Compliance

The product has been manufactured and supplied in compliance with all relevant regulations and directives valid for all member states of the European Union. The product complies with all applicable specifications and regulations in the country of sales.

Formal documentation is available upon request. This includes, but is not limited to, the Declaration of Conformity, the Material Safety Data Sheet, and the product test report.

CE Declaration: This product complies with the following directives:

• LVD: 2014/35/EU
• EMC: 2014/30/EU
• RoHS: 2011/65/EU
• For Products with Radio transmitter units: RED: 2014/53/EU

The complete Declaration of Conformity Document (DoC) can be found here: http://www.shada.nl/uploads/DoCs/index.html

Disclaimer

Designs and specifications are subject to change without notice. All logos, brands, and product names are trademarks or registered trademarks of their respective holders and are hereby recognized as such.

Please visit us online on our website: www.shada.nl for more information about our company and our products.