Product Overview
The LED's Light CONTROL Recessed Ceiling Motion Sensor, PIR 360°, is designed for automatic lighting control. It detects motion within a wide 360-degree field of view.
Specifications and Features
Dimensions:
- Outer Diameter: 80 mm
- Ceiling Cutout Diameter: 70 mm
- Height: 36.08 mm
- Width: 58.95 mm
- Depth: 26.22 mm
Detection:
- Detection Angle: 360°
- Detection Range: 1 - 8 meters
- Optimal Installation Height: 2.2 - 4 meters
Adjustable Settings:
- TIME: Adjustable from 10 seconds to 15 minutes (e.g., 10s, 3min, 10min, 15min).
- LUX Sensitivity: Adjustable from 3 to 2000 lux (e.g., 3, 30, 300 lux).
Installation and Wiring
The sensor is designed for recessed installation into a ceiling. It fits into a standard ceiling cutout of 70 mm.
Wiring Instructions:
Connect the sensor to the AC power supply. The terminals are marked:
- IN: AC power input (Live and Neutral).
- OUT: Connection to the load (e.g., light fixture).
- L: Live wire connection.
- N: Neutral wire connection.
Ensure all connections are secure and correctly made according to local electrical codes.
Safety and Maintenance
Safety Warnings:
- Read and understand all instructions before installation or use.
- Use the product only as described in this document.
- Improper use may cause product damage or personal injury (e.g., short circuit, fire, electric shock).
- Disconnect from power if issues arise.
- Avoid dropping or impacting the device.
- Do not use if any part is damaged or defective. Replace immediately.
- Installation involving non-standard consumer power connections should be performed by a qualified technician to minimize shock risk.
- Ensure the product is adequately ventilated during use.
- Never cover electrical (LED) devices during use, as they can generate heat.
- LEDs can be extremely bright and may cause serious eye damage; avoid direct staring.
- Check product labeling or manual for specific indoor/outdoor use suitability.
- Keep products out of reach of children and animals.
Cleaning and Maintenance:
- Do not use cleaning solvents or abrasive materials.
- Do not clean the inside of the device.
- Do not attempt to repair the device; replace it if it malfunctions.
- Clean the exterior with a soft, damp cloth (avoid microfiber cloths).
Support: For further assistance, comments, or suggestions, please visit: www.shada.nl/nl/contact
Certifications and Notes
- Class II: Double-insulated, no earth connection required.
- IP20: Protected from touch by fingers and objects greater than 12 mm.
- Non-Dimmable: This product is not designed for dimming.
- CE Mark: Confirms compliance with EU safety, health, and environmental protection requirements.
- WEEE Symbol: Indicates separate disposal and recycling according to local environmental regulations.
- Warranty Note: Opening the device in any way other than described will void the warranty.
