Sealey - Leading Professional Tool & Workshop Equipment Supplier
Instruction Manual for SEALEY models including: LED2001 Rechargeable Inspection Light, LED2001, Rechargeable Inspection Light, Inspection Light, Light
Rechargeable Inspection Light 16W COB LED & 1W SMD LED - Anvil Tool
File Info : application/pdf, 2 Pages, 388.78KB
DocumentDocumentRECHARGEABLE INSPECTION LIGHT, 16W COB & 1W SMD LED, 2000LM, ROTATING MAGNETIC BASE MODEL NO: LED2001 Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions, and properly maintained, give you years of trouble free performance. IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE. 1. SAFETY 1.1. GENERAL SAFETY 9 Ensure the light is fully charged before initial use. 8 DO NOT turn the light on when it is being charged. 8 DO NOT shine directly into your, another person's or an animal's eyes. 8 DO NOT allow children to use the light. 8 DO NOT handle or move the light whilst it is being charged. 8 DO NOT use the light if you suspect that the battery or the light casing is damaged. 8 DO NOT leave battery in a discharged state, recharge battery immediately. Before storage, fully recharge the battery, subsequently recharge the battery at least once every six months of non-use. 1.2. BATTERY SAFETY WARNING! To reduce the risk of burns or fire: 8 DO NOT attempt to open, disassemble, modify or service the battery pack. 8 DO NOT crush, puncture, short external contacts or dispose of in fire or water. 8 DO NOT expose to temperatures above 60°C (140°F). 9 Recycle or dispose of used battery as stipulated by local regulation. 9 If the electrolyte in the cells gets on your skin, thoroughly wash with soap and water. If it gets in your eyes, rinse thoroughly with cool water and seek immediate medical attention. 2. INTRODUCTION FIG.1 Smooth 90° flex with additional 360° twist function enables the light source to be positioned in any direction. Super bright 16W COB LED provides up to 2000 lumens output with 120° spread of light, illuminating the whole work area. Includes an additional high power 1W SMD LED directional torch. Features a swivel hanging hook and rubber covered magnet on the base, which allow hands-free operation. Two high quality 2.6Ah lithium-ion batteries for longer life. Supplied with Type-C USB cable. 3. SPECIFICATION MODEL NO: Battery: Charging Time: IP Rating: LED Type: Length: Lumen Output: Operating Time: LED2001 3.7V 2.6Ah Lithium-ion (x2) 5hr IP54 16W COB + 1W SMD 240mm Side(High/Low)/Top: (2000/1000)/120lm Side(High/Low)/Top: (3hr/5hr)/15hr 4. OPERATION ON/OFF MAGNETIC SWIVEL BASE 4.1. 4.1.1. 4.1.2. 4.2. 4.2.1. 4.2.2. CHARGING THE LIGHT Connect the USB cable to the USB INPUT on the rear of the light. Plug the USB cable into supply and turn on. OPERATING THE LIGHT WARNING! Direct the lens away from your eyes before switching on the light. Toggle the light between main light (50-100%), torch and OFF by pressing the ON/OFF switch (fig.1) The light may be suspended by the hook on rear of light or attached to any ferrous surface by using the magnet in the base. 5. MAINTENANCE 5.1. Keep the torch clean by wiping with a damp cloth. 5.2. Store torch in a dry childproof area. IMPORTANT WARRANTY INFORMATION The battery fitted to this light is considered to be a consumable item and its ability to accept a charge will reduce over time. We will provide warranty against mechanical and electrical defect for a period of one year - this DOES NOT cover fair wear and tear. If the battery is not properly charged before first use, or regularly conditioned, its capacity will diminish. Under these circumstances we will not replace the battery regardless of whether it is less than one year old. © Jack Sealey Limited Original Language Version LED2001 Issue 1 19/02/24 ENVIRONMENT PROTECTION Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids according to local regulations. REGISTER YOUR PURCHASE HERE WEEE REGULATIONS Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment (WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid waste authority for recycling information. BATTERY REMOVAL Under the Waste Batteries and Accumulators Regulations 2009, Jack Sealey Ltd are required to inform potential purchasers of products containing batteries (as defined within these regulations), that they are registered with Valpak's registered compliance scheme. Jack Sealey Ltd's Batteries Producer Registration Number (BPRN) is BPRN00705. Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice. Important: No Liability is accepted for incorrect use of this product. Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim. Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR 01284 757500 sales@sealey.co.uk www.sealey.co.uk © Jack Sealey Limited Original Language Version LED2001 Issue 1 19/02/24