Intex Fiber-Tech Dura-Beam Airbed Owner's Manual

Important Safety Instructions

Read and follow all instructions before using this product.

• NEVER PLACE AN INFANT TO SLEEP ON AIR MATTRESSES.
• Never introduce any flammable substance into the inflatable airbed, SUCH AS AEROSOL TIRE REPAIR PRODUCTS, as it may ignite or explode.
• Only for domestic use. Only for indoor use.
• This is not a toy. Children should be supervised to ensure that they do not play with the appliance/airbed.
• Do not walk, stand on or jump on or use the airbed as a trampoline.
• Do not use on or near water. This is not a raft.
• Do not set up bed near stairs, doors, sharp edges or breakable objects. Provide adequate space between bed and objects to avoid entrapment.
• Make sure the area is flat, smooth, even and free of sharp objects that could puncture the bed.
• Keep pets away from the airbed. Pets may puncture the surface of the bed.
• Avoid sleeping on the edge of the airbed. Edges produce less support than the middle of the bed.
• Recommended working pressure: 0.025bar (0.36psi). Rated maximum weight capacity: Model 64701/64707: 136kg (300Lb); Model 64702/64703/64708/64709: 273kg (600Lb).
• FOLLOW THESE RULES AND ALL INSTRUCTIONS TO AVOID SUFFOCATION, PROPERTY DAMAGE OR OTHER INJURY.

To Inflate

1. Make sure the air pump inflation valve insert plug is properly positioned and the 2 in 1 exhaust valve cap is securely tightened.

2. Pull 2 in 1 valve cap to open.

3. Insert the nozzle from an air pump into the 2 in 1 inflation valve.

4. Inflate the product to approximately 80% of desired firmness. CAUTION: To prevent bursting, do not over inflate or use high pressure air compressor.

5. Close 2 in 1 valve cap securely after inflation.

To Deflate

1. Pull out 2 in 1 valve cap.

2. Pull inflation valve base to release air. CAUTION: When opening, point the exhaust valve away from any person.

3. Replace inflation valve base and cap securely.

Important Note

Proper inflation of the airbed is affected by ambient temperatures. At low temperatures, air contracts, making the airbed feel softer; add air as needed. At high temperatures, air expands, making the airbed hard and potentially causing it to burst; release air to avoid damage or soften the feel. Do not expose the airbed to extreme temperatures (hot or cold).

Air inside the bed may expand and contract with varying temperatures, leading to reduced pressure. If this occurs, simply add more air using the pump to achieve the desired firmness. If a puncture occurs, refer to the repair instructions. Repair kit/patch is enclosed.

Stretching is a natural characteristic of new vinyl. During initial use, the airbed may become soft and require additional inflation to maintain desired firmness. This is normal for the first few days of use.

Dimensions shown are approximate and will vary due to vinyl temperature and air temperature.

In no event shall Intex, their authorized agents or employees be liable for damages (such as pin holes) to the airbed caused by negligence, ordinary wear and tear, abuse and carelessness, or external forces.

Maintenance

For cleaning, use only a mild soapy solution. Do not use any chemicals.

For repairs, use only common PVC repair glue and patches.

Storage

1. Make sure the airbed is completely deflated, clean, and dry.

2. Lay the bed flat with the sleeping surface facing upwards and follow the folding steps shown in the figures (1-5). Fold the airbed loosely and avoid sharp bends, corners, and creases that can damage the airbed.

3. Store in a safe, dry, and cool place when not in use.