Instruction Manual for jura models including: GIGA X8c, GIGA X3c, GIGA X8c Automatic Coffee Machines, Automatic Coffee Machines, Coffee Machines, Machines
26 мар. 2025 г. — Important information about installing GIGA automatic coffee machines with a ... Overview: On-site requirements and installation instructions .. Mains ...
E Before the JURA service technician can correctly install the GIGA X8c/X3c, certain preparations are necessary on site. The following preparations must be carried out professionally (in accordance with European standard EN 1717 (fluid category 4)).
File Info : application/pdf, 2 Pages, 254.77KB
DocumentDocumentImportant information about installing GIGA automatic coffee machines with a permanent water connection (GIGA X8c / GIGA X3c) en E Before the JURA service technician can correctly install the GIGA X8c/X3c, certain preparations are necessary on site. The following preparations must be carried out professionally (in accordance with European standard EN 1717 (fluid category 4)). Overview: On-site requirements anA d insB tallaC tionD instrE uctioF ns G H I K L M N O P Q R 1 147 2 103 3 4 551 448 5 6 .. Mains connection q 7 123 59.5 Shut-off valve (max. 28 bar) Fine filter 8 Metal hose w 321 Residual water hose e 220 496 9 160 160 58 Festwasseranschluss 10 J OpeRnes,twuasnseprarbelasusf urised connection between resiTdreustaerldwirekatatbewrurhf ose and waste water pipe 11 276 THIS DRAWING IS THE EXCLUSIVE PROPERTY OF JURA ELEKTROAPPARATE, AND MUST BE RETURNED AFTER COMPLETING OF THE CONTRACT. THE DRAWING MUST ONLY BE USED FOR THE PURPOSE FOR WHICH IT IS SUPPLIED. THE CONTENTS OF THIS DRAWING ARE STRICTLY CONFIDENTIAL AND MUST NOT IN ANY CIRCUMSTANCES BE COPIED, SHOWN, PUBLISHED OR OTHERWISE DISCLOSED TO ANYONE OUTSIDE JURA ELEKTROAPPARATE WITHOUT ITS EXPRESS CONSENT IN WRITING. COPYRIGHT - JURA ELEKTROAPPARATE AG © System separator (at least type BA) 13 J on site 14 optional JURA water filter system15 220 70 Drain, siphon 320 J on site ±0.1 ±0.2 ±0.3 ±0.4 ±0.6 6 30 120 400 1000 6 30 120 400 Jura-General Tolerance (mm) over 0 to A B C D E F G H I K L M N O P Q R Mains connection q U The mains connection must be protected by a residual current device (RCD). U It must be possible to interrupt the power supply using a main switch. On-site permanent water connection (external thread G 3/4") w U Must have a shut-off valve, filter and system separator (at least type BA) U Water pressure from local network: max. 2-8 bar (without pressure surges) Residual water hose and drain When using a residual water hose: U The hose should be installed as short as possible and with the maximum possible inclination (in the fall line). e U During installation, avoid a counter-inclination of the hose or the formation of a siphon in the residual water hose. U It must be possible to ventilate and evacuate air from the hose. This is achieved by an open, unpressurised connection between the residual water hose and the waste water pipe. U There should be a siphon in the waste water pipe installed on site. We always recommend using a JURA water filter system with your GIGA with a permanent water connection 2