CRUIFU

REMOTE RED & INFRARED LED LIGHT THERAPY BELT

INSTRUCTION BOOK

Product display

Dimensions: 51.2 in (length) x 21.3 in (width) x 8.5 in (depth)

Lighting Zone: Features 5 zones labeled A, B, C, D, E.

LED Details:

Tips: The LED lamp light is not waterproof and cannot be used in water or wet places. Especially it cannot be used with essential oils. Please do not forcibly fold it, because it has a built-in circuit board.

Package

Near infrared

Usually uses 660nm with 850nm lamp beads for better effect.

Invisible near infrared energy is absorbed by muscle and subcutaneous tissue, resulting in a THERMAL EFFECT. Your body responds to this radiation heat with increased blood flow, allowing the parts of the body to receive the oxygen and nutrients they need to function more effectively, stimulating regeneration.

Infrared light treatment has a certain weight loss effect. Weight loss should also be combined with exercise for more obvious results.

Operation Instructions

To connect and use:

  1. Connect the belt with the power supply or power bank. The light flashes once to indicate the belt is ready for normal use.
  2. Press "Power ON/OFF" to turn on or off the belt.
  3. Press "ALL Level" to adjust the levels of all areas. There are 5 levels in total (L1-L5).
  4. Press "Select Area" to select an area (there are 5 areas in total). The selected area will flash.
  5. Press "Area Level" to control the level of the selected area (L0(off), L1-L5).
  6. Press "Time Setting" to set the timer (10/20/30/40/50min). The blue light on the belt will light up. "07" means continuous operation without countdown. "10/20/30/40/50" starts the countdown.
  7. The remote control will pause after 5 seconds of inactivity. Press any button to wake it. The remote control distance is about 5 meters, and the best effect is within 2 meters.

Notes:

  • Automatic memory function: belt area level settings will be retained.
  • The maximum continuous working time of the belt is 4 hours, and the belt automatically closes after 4 hours.
  • If the belt cannot be controlled normally during use, please reconnect the power supply or remove and reinsert the battery in the remote control.
  • When the remote controller becomes unresponsive, replace the batteries as they may be low power.

It is recommended to use it for 20 minutes a day.

Two power supply modes:

  1. Connect with a 12V power adapter (recommended).
  2. Use the provided USB cable to connect to a power bank. Note: The maximum power of the belt is 18W. The minimum output capacity of the mobile power bank is recommended to be 5V/3A when using your own mobile power bank. At the same time, use the highest level not more than L3 level. Otherwise, the belt may automatically shut down, the light may flash, or the charging interface may become hot due to insufficient output capacity of the power bank.

For small areas such as legs and arms, roll up one side of the belt and then secure it to the required part.

Caution

After-sales service

Thank you for choosing our product. Please keep this manual properly for future reference. Please feel free to contact us if you have any questions during use. We will provide assistance at the first opportunity.

If there is any quality problem with the product within 1 year, we promise to replace it with a new product for free. Please contact us via: cruifu@outlook.com

Models: L1-L5 Red Light Therapy Belt, L1-L5, Red Light Therapy Belt, Light Therapy Belt, Therapy Belt, Belt

PDF preview unavailable. Download the PDF instead.

C1JeNu7kRsL Corel PDF Engine Version 21.0.0.593 CorelDRAW 2019