dormakaba RCI 909 Rocker Switches

909 Surface Mount Instructions

1. Remove decorative bezel around switch.
2. Optional: To convert the momentary switch provided to maintained switch mode, carefully remove the spring located under the rocker switch with a small screwdriver or pliers.
3. Mount switch base in desired location.
4. Connect wires under appropriate terminals (See Figure 1).
5. Replace decorative bezel.

909 Flush Mount Instructions

1. Pry off decorative bezel around switch and remove toggle.
2. Cut a 2-1/4” x 1-1/4” hole in the drywall.
3. Connect wires under appropriate terminals (See Figure 2).
4. Insert switch into hole. Tighten the two metal slot screws, until switch is secure.
5. Replace toggle and decorative bezel.

Diagrams

The surface mount switch features a central rocker with an indicator resembling a key [key-symbol].

Terminals are labeled:

• "C - Power In" for the incoming power connection.
• "N/C Contact Power Out" for Normally Closed contact output.
• "N/O Contact Power Out" for Normally Open contact output.

The switch is rated 10A @ 250V.

The flush mount switch also features a central rocker with an indicator resembling a key [key-symbol].

Terminals are labeled:

• "C - Power In" for the incoming power connection.
• "L2" and "L3" for output connections.
• "N/C Contact - Power Out" for Normally Closed contact output.
• "N/O Contact - Power Out" for Normally Open contact output.

The switch is rated 10A @ 250V.

Specifications

NOTE: Specifications are subject to change without notice.
N/C - Normally Closed, N/O - Normally Open, C - Common
* Surface mounted switches only may be converted to Maintained Switch Mode.