SWB7140 Installation Instruction

Parts Included

(A) M5x14 screws (4)
(B) M6x14 screws (4)
(C) M6x30 screws (4)
(D) M8x20 screws (4)
(E) M8x45 screws (4)
(F) Washer (5/6/8mm) (4/5/4)
(G) Plastic Sleeve (8x5mm) (8)
(H) Plastic Sleeve (8x15mm) (4)
(I) M6x12 screws (4)
(J) M6 nut (4)
(K) M6x10 Screws (2)
(L) Allen Key (3/4/5/6mm) (one of each size)
(O) M6x18 Socket Set Screw (2)
(P) M6x12 Socket Set Screw (1)

Step 1: Pole Assembly

Prepare the main pole (P-e) and the base component (P-d). Remove the screw (T) from the pole (P-e) using an Allen key (L).

Diagram description: The main diagram illustrates the assembled Sinox SWB7140 TV floor stand. It highlights a 'Cable management hole' on the vertical pole and indicates the 'Center line' for alignment. The stand features a stable circular base.

Step 2: Attaching Pole to Base

Insert the pole (P-e) into the base component (P-d). Ensure the pole is aligned with the center line. Attach the ring (O) around the pole using the set screw (P). The pole has a cable management hole.

Diagram description: In Step 2, the pole (P-e) is inserted into the base component (P-d). A ring (O) is placed around the pole and secured with a set screw (P), indicated by an arrow showing insertion force. The pole's cable management hole is visible.

Step 3-A: VESA Bracket Assembly

Attach the VESA mounting bracket assembly (P-a, P-b, K, L, F, G,H) to the base plate. Use screws (A to E) and washers (F) as indicated. Plastic sleeves (G, H) are used for alignment.

Diagram description: Step 3-A details the attachment of a VESA mounting bracket assembly. Components labeled P-a, P-b, K, L, F (washer), G,H (plastic sleeves), and screws (A to E) are shown in an exploded view, connecting to a base plate.

Step 3-B: Alternative VESA Bracket Assembly

Attach an alternative VESA mounting bracket assembly (P-a, P-b, P-c, J, I, K, L, F, G,H) to the base plate. Use screws (A to E) and washers (F) as indicated. Plastic sleeves (G, H) are used for alignment.

Diagram description: Step 3-B presents an alternative VESA mounting bracket assembly. Components labeled P-a, P-b, P-c, J, I, K, L, F (washer), G,H (plastic sleeves), and screws (A to E) are shown in an exploded view, connecting to a base plate.

Step 4-A: Monitor Attachment and Tilt

Mount the monitor onto the assembled stand. The stand allows for a tilt adjustment of ±45 degrees.

Diagram description: Step 4-A illustrates the final stage where a monitor is attached to the stand. The diagram indicates that the monitor can be tilted up to ±45 degrees.

Step 4-B: Monitor Attachment and Tilt