Test & Finish
Open a word processing program such as Microsoft Word or Notepad and scan the following barcode:
If the word "Unitech" appears on the screen, you have successfully installed your scanner.
Default Setting
Factory default settings are indicated with an asterisk (*).
Pairing Function
Bluetooth HID Pairing
The scanner can be searched by other Bluetooth devices after scanning the Bluetooth HID pairing code.
Upgrade
- One long beep: Switch on
- One low beep and two high beeps: Setup code or data saved.
- One short beep: Pairing up with the receiver successfully.
- One short low beep and one short high beep: Good Read and data send.
- Three continuous short beeps: Alarm prompt
Wireless Bluetooth Setting
Bluetooth HID: [Barcode for Bluetooth HID]
Bluetooth SPP: [Barcode for Bluetooth SPP]
IOS Show / Hide the Keyboard
Battery Display
Display battery capacity. Note: Battery Percentage display.
USB Interface Type
- USB-HID
- USB-COM
Operation Mode
- *Auto Mode: [Barcode for Auto Mode]
- Batch Mode: [Barcode for Batch Mode]
- Clear all data: [Barcode for Clear all data]
- Wedge Mode: [Barcode for Wedge Mode]
- Upload all data: [Barcode for Upload all data]
- Display stored data: [Barcode for Display stored data]
Beeper Control
- Off: [Barcode for Beeper Off]
- *High: [Barcode for Beeper High]
- Medium: [Barcode for Beeper Medium]
- Low: [Barcode for Beeper Low]
Note: The Off Code only turns off the short high beep of data send; the setting sound still exists.
Terminator
- TAB: [Barcode for TAB Terminator]
- CR: [Barcode for CR Terminator]
- None: [Barcode for None Terminator]
- LF: [Barcode for LF Terminator]
Auto Power Off After Idle
- Immediate sleep: [Barcode for Immediate Sleep]
- 10 s: [Barcode for 10s Sleep]
- 30 s: [Barcode for 30s Sleep]
- *1 min: [Barcode for 1min Sleep]
- 2 min: [Barcode for 2min Sleep]
- 5 min: [Barcode for 5min Sleep]
- 10 min: [Barcode for 10min Sleep]
- 30 min: [Barcode for 30min Sleep]
Software Version
Scan the following barcode to display the software version.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
RF Exposure Information
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
