Panel Installation Guide

Base Models

• SRBC052D3SS-P
• SRWC052D3SS-P
• SRWBC052D3SS-P

Please Note

• Max. panel thickness: 3/4" (19mm)
• Max. weight of panel: 20 Lbs (10 Kg)
• Cabinetry frame 'panel' and handle to be supplied by customer.

Panel Dimensions

Diagram Description: Illustrates the dimensions for the front, back, and top of the panel. The front view shows a height of 746mm (29 3/8"), a width of 602mm (23 3/4"), and a depth of 20mm (3/4"). The back view shows similar front dimensions. The top view indicates a panel thickness of 16mm (5/8") and a 10mm (3/8") clearance. Key measurements for hinge clearance are also noted on the front view.

Suggested Equipment

• Drill and 7/64" (3mm) Drill Bit
• Bar Clamps/Tape
• Phillips Head Screwdriver

Preparation

1. Cut the panel to dimensions shown, including the slots for hinge clearance.
2. If applying stain or finish, follow instructions on the product and consider finishing both sides to prevent warping. In some frame installations, the panel may be visible through the glass while the door is open.
3. Install desired handle, ensuring screws sit flush with the back face of the panel.

Installation Instructions

1. Fully open door.
2. Starting at the corner, pull the gasket away from the door. (See Fig. A: Diagram shows gasket being pulled from the door channel).
3. Continue to pull the gasket free from the gasket channel.
4. Upon removal, lay the gasket down on a flat surface.
5. Secure integrated panel to door using clamps. It is recommended to use bar clamps to secure the panel to the door. A robust tape may also be used. If using tape, ensure the tape will not damage the panel finish upon removal. (See Fig. B: Diagram shows a wood panel secured to a door/drawer using bar clamps).
6. Using a 7/64″ (3mm) drill bit, drill 6 pilot holes into the wood panel 1/2" (12mm) deep using the holes in the door frame as a guide.

   Notice: It is important to ensure that all drill holes are drilled to the correct depth in order to avoid splits in the wood when hardwood is installed.

7. Locate 6 of the ST4x 25mm screws provided with your unit.
8. Using a Phillips screwdriver, place one screw into each of the 6 pilot holes and screw down. Do not over tighten the screws. (See Fig. C: Diagram shows a close-up of screws being inserted into pilot holes in the panel).
9. Ensure the screws sit flush against the bottom of the channel. Remove clamps from the door.

   Notice: If panel requires additional adjustment after removing clamps, slightly loosen each screw and adjust panel as necessary. Tighten screws upon completion.

10. Starting at the corners, re-install the gasket into the gasket channel in the frame. Make sure the gasket is fully seated.