Hilti TE 3000 (03) SH-Clip Installation Guide
Document Number: 2379271-09.2022
Model Compatibility
Step 1: Identify Your Tool Model
This guide details the attachment of the SH-Clip accessory. First, verify your Hilti TE 3000 model:
- TE 3000 (01/02) (Produced 2011 - 2021):❌ [Not Compatible]Visual representation shows the older model with a prohibition symbol, indicating it is not compatible with this clip.
- TE 3000 (03) (Produced 2021 onwards):✔️ [Compatible]Visual representation shows the newer model with a checkmark symbol, indicating compatibility. A close-up highlights the tool's chuck area.
Relevant accessory part numbers:
- Clip: #2107829
- Clip retainer: #2366679
Attaching the SH-Clip
Step 2: Install the Clip onto the Chuck
For the compatible TE 3000 (03) model:
⬆️ [Insert] the clip (part #2107829) onto the tool's chuck mechanism.
Diagram illustrates the clip being fitted onto the tool's chuck. Red arrows indicate the direction of insertion.
?️❗ [Attention Required] Ensure the clip is correctly seated and secured in the designated groove.
A close-up view shows the clip properly positioned in the chuck. An eye and exclamation mark symbol highlights the importance of correct seating.
Final Configuration
Step 3: Confirm Attachment and Model Designation
The SH-Clip is now correctly attached to the Hilti TE 3000 (03) tool.
Image sequence shows the tool with the clip attached, followed by a separate view of the clip, and then the tool again with the clip in place.
This accessory configuration is identified as TE SH-STD.
A final visual displays the Hilti logo, the "TE SH-STD" designation, and illustrations of the clip and its installation on the tool.
