BRINK Air for Life

Step 1

Connect to power. Illustration shows a power plug being connected to a socket, accompanied by a warning symbol.

[power plug] ⚠️

Step 2

Prepare the appliance. Illustration shows the heat exchanger unit with an arrow indicating to approach the front panel.

[appliance] [arrow pointing to front panel]

Step 3

Open the appliance front panel. Illustration shows the front panel of the unit with two doors opening outwards, guided by arrows.

[front panel doors opening]

Step 4

Remove screws (2x Torx T20) and open the panel completely. Illustration shows the unit with front panel doors open, indicating the removal of two Torx T20 screws for full access.

[open front panel with screw locations]

Step 5

Remove the old heat exchanger. Illustration shows the old heat exchanger being removed from the appliance.

[heat exchanger removal]

Step 6

Place the enthalpy heat exchanger into the appliance. Illustration shows the new enthalpy heat exchanger being inserted into the appliance. It is identified as 'Enthalpy heat exchanger, Article code: 532710'.

Enthalpy heat exchanger (Article code: 532710)

[heat exchanger insertion]

Step 7

Close the appliance front panel. Illustration shows the front panel doors being closed, with an arrow indicating the closing motion.

[front panel closing]

Step 8

Manage condensate discharge. A = Remove condensate discharge. B = Close the condensate discharge with the supplied cap. Illustration shows the condensate discharge management: A) removal of the discharge pipe, and B) closing the discharge port with the supplied cap. A warning symbol is present.

A = Remove condensate discharge.

B = Close the condensate discharge with the supplied cap.

[condensate discharge management] ⚠️

Step 9

Connect to power (230V 50Hz). Illustration shows the power connection for the appliance.

[power plug] [power socket]