Ubiquiti IsoBeam™ Quick Start Guide
Isolator Radome for 620 mm Dish Reflector
Model: ISO-BEAM-620
Introduction
Thank you for purchasing the Ubiquiti Networks® IsoBeam™. The IsoBeam is compatible with the RD-5G30-LW, PBE-M5-620, and PBE-5AC-620. The IsoBeam is secured to a dish reflector using a band clamp and a screw.
Hardware Overview
The IsoBeam is a white, circular radome designed to fit over a dish reflector. It features a band clamp around its outer edge, secured by a screw. Multiple small holes, labeled as "Drainage Holes", are located around the bottom perimeter of the radome to allow water to escape.
Installation
Loosen the screw and detach the band clamp from the IsoBeam.
Seat the dish reflector inside of the IsoBeam with the drainage holes facing down to the ground.
[Description of image: A dish reflector is shown being placed inside the IsoBeam. The drainage holes on the IsoBeam are oriented downwards.]
Wrap the band clamp around the IsoBeam and dish reflector.
[Description of image: The band clamp is being wrapped around the assembled IsoBeam and dish reflector.]
Secure the band clamp by tightening the screw.
[Description of image: The screw on the band clamp is being tightened. A torque specification of 10 N-m is indicated.]
Installation is complete.
