U9 WiFi Repeater Quick Installation Guide

Method ONE: Using WPS (Wi-Fi Protected Setup)

Using WPS is an easier way to extend your host network. It is recommended if your host router has a WPS button. The button might look like WPS or .

1. Press the WPS button on your router.
2. Within 2 minutes, press the WPS button on the extender for 1 second.

Wait for the LED to be solid green. You can find the network names with _EXT in your Phone Wi-Fi network list, indicating a successful WPS connection. If not, please use Method TWO.

Method TWO: Using a Web Browser

For Mobile phone users:

1. Find the SSID (Network Name) printed on the label of the U9 router.
2. Connect your Mobile phone to the U9 router's network (e.g., Extender-a4f97c).
3. Launch a web browser and type http://192.168.11.1 in the address field. If the phone is connected to the repeater for the first time, a login page will automatically pop up.
4. Use admin (all lowercase) for the Password to log in.
5. Select Repeater mode and click Next.
6. Select the host network and enter your Host router's password.
7. Click and follow the instructions on the page to complete the configuration.

Wait for the LED to be solid green. You can find the network names with _EXT in your Phone Wi-Fi network list.

Relocate

1. Plug the extender into an electrical outlet between your router (Host Network) and the Wi-Fi “dead” zone. The location must be within the range of your existing host network.
2. Wait until the LED is lit and solid Green. If not, relocate it closer to the router to achieve a good signal quality.

Configuration Steps:

1. Connect your router to the U9 router using an Ethernet cable to the LAN/WAN port.
2. For Mobile phone users:
   1. Find the SSID (Network Name) printed on the label of the U9 router.
   2. Connect your Mobile phone to the U9 router's network (e.g., Extender-a4f97c).
   3. Launch a web browser and type http://192.168.11.1 in the address field.
   4. Use admin (all lowercase) for the Password to log in.
3. Select AP mode and click Next.
4. You can either keep the existing SSID and Password or customize them for the extended network.
5. Click and follow the prompts on the page to complete the AP mode configuration.

Hardware Connections:

• If your Internet connection is through a DSL/Cable modem, follow steps 1, 2, and 4.
• If your Internet connection is through an Ethernet cable from the wall, follow steps 3 and 4.

Connect the router to your modem or wall Ethernet port using the LAN/WAN port.

Configuration Steps:

1. For Mobile phone users:
   1. Find the SSID (Network Name) printed on the label of the U9 router.
   2. Connect your Mobile phone to the U9 router's network (e.g., Extender-a4f97c).
   3. Launch a web browser and type http://192.168.11.1 in the address field.
   4. Use admin (all lowercase) for the Password to log in.
2. Select Router mode and click Next.
3. Select your internet connection type from the drop-down list (Dynamic IP, Static IP, or PPPoE).
4. Set up Your Internet Connection:
   
   • Dynamic IP: Typically used with cable TV or fiber cable.
   • Static IP: Enter the information provided by your ISP in the corresponding fields.
   • PPPoE: Typically used with DSL cable modems. Enter the username and password provided by your ISP.
5. You can either keep the existing SSID and Password or customize them for the extended network.
6. Click and follow the prompts on the page to complete the Router mode configuration.