The Sharper Image Automatic Eyeglass Cleaner

Dear Sharper Image Customer,

Thank you for your purchase of a Sharper Image product. The Sharper Image appreciates your business very much.

This item was created by Sharper Image Design, the company's own product development group. The Sharper Image provides personal assurance of complete satisfaction with this product's quality and performance. Generous return privileges and excellent warranties are offered on all products.

For more than 25 years, The Sharper Image has shared the fun of discovering innovative products that make life better and more enjoyable. The company has been in business a long time because it is an exciting place to shop and — just as importantly — it strives to deliver great customer service that exceeds customer expectations.

Enjoy your purchase!

Respectfully,

Richard Thalheimer
Founder, Chairman and Chief Executive Officer

For 24/7 ordering and customer service, call 1-800-344-4444 or visit www.sharperimage.com, the complete online store.

General Description

The Automatic Eyeglass Cleaner and its specially formulated concentrate work together to loosen grime and condition eyeglasses. The complete cleaning and drying cycle takes less than 60 seconds.

The unit consists of a Base, a Cleaning Tank with a removable Cover, an Eyeglass Clip that attaches to a Clip Dock, and a Polishing Cloth. Buttons on the unit allow users to 'Press to Open' the cover and 'Press to Start' the cleaning cycle. The Polishing Cloth is stored within the unit's Polishing Cloth Storage compartment.

Battery Requirements

1. The battery compartment is located on the bottom of the Base. To remove the battery cover, press the tab in the direction indicated on the cover door.
2. Install four new AA alkaline batteries, ensuring proper +/- polarities are observed. A diagram inside the battery compartment shows the correct orientation for the batteries.
3. Replace the battery cover.

Note: Battery fit will be tight when the unit is new. Press batteries firmly into place.

Battery Safety

• Batteries may leak or explode if recharged, inserted improperly, inserted in the wrong direction, disposed of in a fire, or mixed with different battery types.
• Only replace with fresh, new batteries. It is important batteries are inserted in the correct orientation. (Refer to the diagram inside the battery compartment.) Batteries positioned incorrectly may leak.

Cleaning and Conditioning Concentrate

To raise the Cleaning Tank Cover, press OPEN.

Note: The Cleaning Tank can be removed from the Base.

Shake the bottle of concentrate each time before opening. Pour two capfuls of the concentrate into the Cleaning Tank. Add water up to the fill-line indicated inside the tank. The Cleaning Tank, when in the Base, has a 'Press to Open' point and an internal 'Fill-Line Indication'.

Replace the mixture every two weeks, or as needed, to maintain clean, fog-resistant lenses.

For additional information, refer to the concentrate bottle label. If the Cleaning Tank was removed, return it to the Base.

Attaching Glasses

1. To raise the Tank Cover, press OPEN.
2. Grasp the CLIP by one of the tabs and pull it from the CLIP DOCK. The clip is held in place by a magnet. To remove it from the dock, pull or twist it.
3. Pinch the CLIP open and slip the bridge of the glasses into the clip grips.

Note: Glasses should be facing the same direction as the square-shaped form of the Clip. The clip, when open, is released by grasping and pulling. When glasses are attached, the 'squared' area of the clip faces front, and the lenses of the glasses also face front.

4. Return the EYEGLASS CLIP and glasses to the CLIP DOCK. The magnet holds the clip and glasses in the proper position for cleaning. Be careful not to pinch the Clip open.

To close and latch the Tank Cover, press the center of the Cover.

Operation

Solution that may have splashed into the unit could cause the product to operate incorrectly. Normal operation resumes after the unit has had an opportunity to dry.

• To start, press ON/OFF.
• The glasses are agitated in the solution for approximately 40 seconds. The vibration continues as the glasses are lifted out of the solution, reducing residual solution on the lenses.

After the cycle stops:

Grasp the CLIP by one of the tabs and pull it from the CLIP DOCK. Remove the glasses and use the polishing cloth to wipe the lenses.

The unit features a button to 'Press to activate cleaning cycle' and an option to 'Select dry cycle on or off'. A polishing cloth is included to 'Wipe Lenses with included microfiber cloth'.

Do not soak glasses for an extended period of time. Do not use on frames with delicate or unstable finishes.

One-Year Warranty

What Is Covered

This warranty covers any defects in materials or workmanship, with the exceptions stated below.

How Long Coverage Lasts

This warranty runs for one year from the date of original purchase.

What Is Not Covered

This warranty does not cover damage caused by misuse or use other than as intended and described in the product instruction manual, or loss or damage to batteries or removable parts.

What The Sharper Image Will Do

The Sharper Image will repair any defects in materials or workmanship. In the event repair is not possible, The Sharper Image will either replace this product with one of similar features and price, or refund the full purchase price of the product, whichever is preferred.

How to Obtain Service

Return the product and receipt, along with a brief explanation of the problem, to:

For questions, contact customer service representatives at 1-800-344-5555 or by email at care@sharperimage.com.

This warranty gives specific legal rights, and other legal rights may vary from state to state.

Copyright 2003
Sharper Image Corporation
650 Davis St., San Francisco, CA 94111
(415) 445-6000

Shop online: www.sharperimage.com

Due to continuing improvements, actual product may differ slightly from the product described herein. V2 09/03