Safety Instructions
Please take a few moments to carefully read through this manual. Correct maintenance and operation of this machine will provide the best possible performance from your product.
- Position on a flat, stable surface.
- A service agent/qualified technician should carry out installation and any repairs if required. Do not remove any components on this product.
- Consult Local and National Standards to comply with the following: Health and Safety at Work Legislation, Fire Precautions, Wiring Regulations, Building Regulations.
- Ensure the location for the appliance can support its weight when full.
- DO NOT fill the appliance above the 'MAX' level.
- DO NOT move the appliance when full.
- DO NOT immerse the appliance in water.
- DO NOT leave the machine unattended during operation.
- DO NOT operate this appliance when less than one third full.
⚠️ Danger of burns!
- Do not touch hot surfaces and beware of escaping steam.
- For indoor use only. Do not use outdoors or under extremely cold conditions. Freezing up of the unit may pose a safety hazard.
- Always switch off and disconnect the power supply to the appliance when not in use.
- Keep all packaging away from children. Dispose of the packaging in accordance to the regulations of local authorities.
- If the power cord is damaged, it must be replaced by an Apuro agent or a recommended qualified technician in order to avoid a hazard.
- Please ensure that the tap is screwed fully on before use.
- Apuro recommend that this appliance should be periodically tested (at least annually) by a Competent Person. Testing should include, but not be limited to: Visual Inspection, Polarity Test, Earth Continuity, Insulation Continuity and Functional Testing.
Telephone Helpline: 1300225960
Appliance Usage and Safety
This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.
Pack Contents
The following is included:
- Apuro Water Boiler
- Instruction manual
Apuro prides itself on quality and service, ensuring that at the time of unpacking the contents are supplied fully functional and free of damage. Should you find any damage as a result of transit, please contact your Apuro dealer immediately.
Operation
Important: Do not install the appliance in an area where a water jet could be used.
Before using for the first time, clean the interior with warm water then dry well.
- Remove the appliance from the packaging. Make sure that all protective plastic film and plastic coatings are thoroughly removed from all surfaces.
- Ensure the Temperature Control knob is set to 'OFF'.
- Remove the lid and fill the appliance to at least half of its capacity.
- Replace the lid.
- Connect to the mains power supply.
- Set the Temperature Control knob to the required temperature setting. The 'BOIL' indicator light illuminates and the appliance begins to heat water.
- When the water has reached the set temperature the 'BOIL' Indicator light turns off and the 'KEEP WARM' indicator light illuminates.
Diagram Description: The appliance is a stainless steel water boiler. It features a lid on top with a handle. A tap is located on the lower front. Indicator lights are present: a 'KEEP WARM' indicator light and a 'BOIL' indicator light. A Temperature Control knob is located below the tap.
WARNING: Reduce the set temperature if the water begins to boil. DO NOT allow the water to boil constantly.
Note: Once the water temperature drops 5-10°C then the appliance will reheat the water.
WARNING: If the Temperature Control Knob is set to or close to 'HIGH' then the appliance will constantly heat the water until knob is turned to 'OFF' or the temperature is reduced.
Serving
Emptying the Appliance
Drain the appliance by using the tap to empty.
Thermal Cut-Out Reset
This appliance is fitted with a Thermal Cut-Out safety feature. Should the temperature exceed safe levels the appliance will automatically cut power. The Safety Cut-out switch is located on the underside of the appliance.
To reset the appliance:
- Empty the appliance and allow to cool.
- Press the reset button until it clicks.
WARNING: Ensure the appliance has cooled down and is empty before resetting the switch, as it may need to be tipped slightly to gain access to the switch.
3. The appliance is now reset and can be used as normal.
Cleaning, Care & Maintenance
- Always turn off and disconnect the appliance from the power supply before cleaning.
- Use soapy water and a damp cloth to clean the exterior of the appliance.
- Dry thoroughly after cleaning.
De-scaling
For the best water quality, Apuro recommend that a water filter is installed to the mains water supply, particularly in hard water areas. Doing so will reduce the build up of limescale and contaminants in the water tank thus maintaining energy efficiency and prolonging the life of the appliance.
To de-scale the appliance:
- Pour a solution of de-scaler and water into the appliance.
- Brush the interior gently with a soft bristled brush.
- Discard the solution collected in the jug.
- Fill the appliance with clean water and turn back On to flush out the system. Flush out the system thoroughly to remove any de-scaler residue.
- The appliance is now ready for use.
Note: Use a suitable de-scaler and always follow the instructions on the container.
Apuro recommend that this appliance is de-scaled every 3 months or more frequently in hard water areas.
IMPORTANT: Failure to de-scale or maintain will invalidate your guarantee.
Troubleshooting
A qualified technician must carry out repairs if required.
| Fault | Probable Cause | Solution |
|---|---|---|
| The unit is not working | The unit is not switched on | Check unit is plugged in and switched on |
| Plug or lead is damaged | Replace Plug or lead | |
| Mains power supply fault | Check mains power supply | |
| Indicator light comes on but water does not reach temperature | Thermostat fault | Consult a qualified technician |
| The tap is leaking | The tap has become loose | Tighten the tap handle |
| No power | Thermal cut-out switch is activated | Check the appliance is safe with no obvious damage then press the reset switch on the underside |
Technical Specifications
Note: Due to our continuous improvement process, the product specifications are subject to change without notice.
| Model | Voltage | Power | Current | Capacity (litres) | Weight (full) (kg) | Heating Time (Max. Temp. when full) | Dimensions h x w x d mm |
|---|---|---|---|---|---|---|---|
| CX876-A | 230-240V~ 50Hz | 2200W | 9.36A | 10 | 15.6 | 29 minutes | 538 x 330 x 330 |
| CX879-A | 20 | 26.1 | 59 minutes | 587 x 380 x 380 | |||
| CX877-A | 30 | 38.6 | 88 minutes | 585 x 490 x 490 | |||
| CX878-A | 40 | 47.5 | 125 minutes | 694 x 490 x 490 |
Electrical Wiring
The plug is to be connected to a suitable mains socket.
This appliance is wired as follows:
- Live wire (coloured brown) to terminal marked L
- Neutral wire (coloured blue) to terminal marked N
- Earth wire (coloured green/yellow) to terminal marked E
This appliance must be earthed. If in doubt consult a qualified electrician.
Electrical isolation points must be kept clear of any obstructions. In the event of any emergency disconnection being required they must be readily accessible.
Compliance
The product must not be disposed of as household waste. To help prevent possible harm to human health and/or the environment, the product must be disposed of in an approved and environmentally safe recycling process. For further information on how to dispose of this product correctly, contact the product supplier, or the local authority responsible for waste disposal in your area.
APURO parts have undergone strict product testing in order to comply with regulatory standards and specifications set by international, independent, and federal authorities.
APURO products have been approved to carry the following symbol: ✔️ [compliance-symbol]
All rights reserved. No part of these instructions may be produced or transmitted in any form or by any means, electronic, mechanical, photocopying, recording or otherwise, without the prior written permission of APURO. Every effort is made to ensure all details are correct at the time of going to press, however, APURO reserve the right to change specifications without notice.
Declaration of Conformity
This document declares that the specified equipment conforms to relevant Territory Legislation, Council Directives, and Standards, including Electrical Safety (IEC 60335 series) and Electro-Magnetic Compatibility (EMC EN standards).
Manufacturer: Apuro
Models Covered: CX876-A, CX879-A, CX877-A, CX878-A
Declaration Date: 15th Oct 2024
Signatories: Ashley Hooper (Group Head of Product Quality & Compliance) and Brendan Denmeade (Commercial Manager/ Responsible Supplier).
