Jewenwils Outdoor Remote Control Countdown Timer

SKU: HODT12B [Instruction Manual]

Please pay attention to the warning signs. Read the instructions with caution before operating and keep them properly.

CAUTION

  • Suitable for use with outdoor appliances.
  • For use ONLY with a three-conductor GFCI protected outlet.
  • Raintight when mounted vertically with receptacles facing downward.
  • Do not immerse in water.
  • DO NOT EXCEED RATED CAPACITY.
  • The device must be mounted in a vertical position with the receptacle facing downward and with the receptacle at least 2 FT above the ground level.
  • Cord-connected Operating Control.
  • Temperature limits of the SWITCH HEAD: -40°C to 40°C.

Installation

  1. Mount or hang the RECEIVER on the wall near a GFCI protected outlet (125V 60Hz) which the power supply cord of the RECEIVER will plug into.
  2. Plug the cord of the device you wish to control remotely at the bottom of the RECEIVER.

Receiver and Transmitter Overview

An illustration shows the receiver unit and a separate transmitter remote. The receiver has a power plug at the top, a control panel with buttons (labeled 'ON', 'Sensor' (sun/moon symbol), '2H', '4H', '6H', '8H', 'OFF'), and two outlets at the bottom. The transmitter is a remote control unit with buttons labeled 'ON', '2H', '4H', '6H', '8H', and 'OFF'.

Operating Instructions

Receiver & Transmitter Operation Modes:

  • ON: Power is ON to attached devices.
  • Sensor (Dusk - Dawn): Power will turn on at dusk and remain on until dawn.
  • 2 Hrs: Power will turn on at dusk and remain on for 2 hours.
  • 4 Hrs: Power will turn on at dusk and remain on for 4 hours.
  • 6 Hrs: Power will turn on at dusk and remain on for 6 hours.
  • 8 Hrs: Power will turn on at dusk and remain on for 8 hours.
  • OFF: Power is OFF to attached devices.

Note for Transmitter: The transmitter can control the electrical outlet up to a distance of 100 feet.

Note: The timer has a daily repeat function after setting. In case of power failure, it will stop operating when the power goes out. Once power is restored, reset the desired operating mode as per the operating instructions.

Helpful Tips

  • When set to "ON", the timer will provide continual power to attached devices until the timer is switched to "OFF", or to any of the other operating modes.
  • In the sensor (dusk-to-dawn) mode, temporary light sources like headlights, porch lights, and other external light sources will not interfere with the photocell function unless the external light source is on for more than 15 minutes. In that case, the timer will shut off until darkness is restored. This improvement avoids flickering.
  • Once programming activates at dusk in the 2hr, 4hr, 6hr, or 8hr mode, the program cycle will complete before the timer resets. Headlights, porch lights, street lamps, and other external lighting sources will not interfere with the active timer program.

Battery Handling and Usage

  • Install the battery observing the positive (+) side up as indicated inside the battery compartment.
  • Never throw batteries into a fire. Do not expose batteries to fire or other heat sources.
  • Battery contains mercury. Do not put in trash. Recycle or manage as hazardous waste.

Battery Replacement

An illustration shows the remote control's battery compartment, indicating the positive (+) terminal and specifying the battery type as CR2032 3V.

  • Remove the battery compartment cover away from the remote.
  • Remove the old battery and place a new Type 3V (CR2032) lithium battery into the battery compartment.
  • Ensure the battery is installed correctly with the positive (+) side up.
  • Replace the battery compartment cover.
  • Dispose or recycle spent/discharged batteries in compliance with all applicable laws. For detailed information, contact your local solid waste authority.

Caution: Failure to properly align the battery polarity can cause personal injury and/or property damage.

WARNING: Chemical Burn Hazard

Do not ingest the battery. This product contains a coin/button cell battery. If the coin/button cell battery is swallowed, it can cause severe internal burns in just 2 hours and can lead to death. Keep new and used batteries away from children. If the battery compartment does not close securely, stop using the product and keep it away from children. If batteries might have been swallowed or placed inside any part of the body, seek immediate medical attention.

Specifications

DO NOT ATTACH A DEVICE THAT EXCEEDS THE UNIT RATINGS:

  • 125 V ac 60 Hz
  • 15 A Resistive
  • 15 A General Use
  • 1000 W Tungsten
  • 500 VA Electronic Ballast, 1/2HP
  • 120 V ac, 60 Hz, 8.3 A Ballast

RECEIVER MODEL: TM-110
TRANSMITTER MODEL: TR-034-7
FCC ID: PAGTR-033-7

Safety Information

Federal Communication Commission Interference Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on. Users are encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and the receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment.

One Year Limited Warranty

Supported by a professional R&D team and QC team, a One Year Warranty is provided for materials and workmanship from the purchase date. The warranty does not cover damage caused by personal misuse or improper installation.

Customers should attach their Order ID and Name so that the dedicated customer service team can provide assistance.

The product is CUL US LISTED.

Models: HODT12B, HODT12B Outdoor Remote Control Countdown Timer, Outdoor Remote Control Countdown Timer, Remote Control Countdown Timer, Countdown Timer, Timer

PDF preview unavailable. Download the PDF instead.

HODT12B-Manual ?v=1684225256 Adobe PDF library 15.00 Adobe Illustrator(R) 17.0

Related Documents

Preview Jewenwils Outdoor Remote Control Countdown Timer HODT12B Instruction Manual
Instruction manual for the Jewenwils Outdoor Remote Control Countdown Timer, model HODT12B. Provides details on installation, operation modes, battery handling, specifications, and warranty.
Preview Jewenwils Outdoor Remote Control Countdown Timer HODT12B2 Instruction Manual
Instruction manual for the Jewenwils Outdoor Remote Control Countdown Timer, model HODT12B2. Includes installation, operating instructions, troubleshooting, battery replacement, specifications, and warranty information.
Preview Jewenwils HOYS16D Outdoor Digital Yard Stake Timer Instruction Manual
Comprehensive instruction manual for the Jewenwils HOYS16D Outdoor Digital Yard Stake Timer, covering installation, operation modes, safety warnings, battery handling, specifications, and warranty information for this consumer-friendly outdoor lighting control device.
Preview Jewenwils HOYS16A1 Outdoor Digital Yard Stake Timer Instruction Manual
Instruction manual for the Jewenwils HOYS16A1 Outdoor Digital Yard Stake Timer, covering installation, operation, battery replacement, and safety information for efficient outdoor lighting control.
Preview Jewenwils Outdoor Digital Countdown Timer HODT12C Manual
Learn how to operate and troubleshoot the Jewenwils HODT12C Outdoor Digital Countdown Timer with this comprehensive instruction manual, covering features, specifications, and safety guidelines.
Preview Jewenwils HOYS22M Mechanical Yard Stake Timer Instruction Manual
Learn how to install and operate the Jewenwils HOYS22M Mechanical Yard Stake Timer with this comprehensive instruction manual. Includes safety warnings, product layout, operating instructions, and specifications for this outdoor electrical timer.
Preview Jewenwils HODT21A Outdoor Light Sensor Timer Instruction Manual
Comprehensive instruction manual for the Jewenwils HODT21A Outdoor Light Sensor Timer, covering installation, operation modes (dusk-to-dawn, timed), safety warnings, specifications, FCC compliance, and warranty information.
Preview Jewenwils Outdoor Mechanical Timer Box HOMT01A Instruction Manual
This manual provides detailed instructions for the installation, operation, and specifications of the Jewenwils Outdoor Mechanical Timer Box, model HOMT01A. Learn how to safely install and use this timer for various electrical applications.