DJI RS 4 Pro Release Notes
Firmware and Software Versions
Date: 2024.07.17
- Firmware: v01.03.00.00
- DJI Ronin Image Transmitter (RavenEye) Firmware: v01.03.00.72
- DJI Ronin Tethered Control Handle Firmware: v32.33
- DJI Ronin App iOS: v1.8.0
- DJI Ronin App Android: v1.8.0
- User Manual: v1.0
What's New?
- Added support for DJI SDR Transmission.
- Optimized the algorithm when the gimbal is upside down and recenters in FPV mode.
- Optimized gimbal performance.
- Optimized the hot swapping experience when using Canon cameras including the EOS 200D Mark II, EOS 800D, EOS 6D Mark II, EOS 80D, and EOS 90D.
- Optimized the recording experience after focusing several times using Sony cameras.
- Optimized Zcam camera control experience.
- Optimized the calibration experience when using a single motor in Z mode.
- Optimized the battery level display when using a third-party accessory.
Notes for Firmware Updates
- Ensure the DJI Ronin app is the latest version before updating the firmware.
- Motor parameters are reset after firmware updates; autotune the gimbal afterward.
- Update firmware using the DJI Ronin app via Bluetooth. Do not disconnect the app or gimbal during the update.
- Update the DJI Ronin Image Transmitter firmware using the DJI Ronin app via Wi-Fi. Do not disconnect the app or transmitter during the update.
- If a camera is attached and powered on during the update, protect the camera and lens as motors will power off temporarily.
- If a firmware update fails, restart the gimbal and retry.
