Dash Cam Mount Installation
Suction Cup Mount Installation
Follow these steps to install your suction cup mount:
-
Step 1
Clean the windshield area where you plan to place the suction cup mount.
-
Step 2
Peel off the plastic protective film on the suction cup mount.
-
Step 3
Ensure the locking lever is in the UP position. ⬆️
-
Step 4
Press the mount's button down with good force. This is what creates the suction. ?
-
Step 5
Rotate the mount's lever down to lock it. ⬇️
-
Step 6
Try and move the mount to check for stability. Attach the dash cam to the mount and adjust the recording angle.
3M Adhesive Mount Installation
Follow these steps to install your 3M adhesive mount:
-
Step 1
Clean the area of the windshield where you plan to stick the 3M adhesive mount.
-
Step 2
Attach the windshield sticker applicator included in the box to the windshield to make it easier to remove the 3M adhesive mount when the dash cam is not in use. [sticker applicator symbol] ➡️
-
Step 3
Peel off the protective film from the adhesive on the mount. ?️
-
Step 4
Press the adhesive side of the mount firmly against the windshield for about 30 seconds. Allow the adhesive to set for 2 hours before attaching the dash cam. ⏱️
-
Step 5
Try and move the mount to check for stability. Attach the dash cam to the mount and adjust the recording angle.