Zadro LED Starlight Projector

Important Safety Instructions

READ ALL INSTRUCTIONS BEFORE USE

For use by adults only. The LED Starlight Projector is NOT a toy and is not intended to be played with or used by children.

Features

• 3 Color LED Starlight Projector: White, Yellow, Blue, Multicolor
• Continuous Play or Auto Off Timer Settings (1hr, 4hr, 8hr)
• White Noise & Sound Spa: 15 Relaxing Sounds with Adjustable Volume
• Touch Control
• Smart Memory: Remembers Last Light, Sound, and Volume Settings
• 2 Power Options: Cordless (batteries not included) or Endless Power (USB power cable included)

Operating Instructions

Turning the Led Starlight Projector On/Off

Tap [tap] on the top of the Led Starlight Projector. The projector light will turn on when [tap] is pressed.

Turning the Projector Light On/Off

With the Led Starlight Projector on, tap [tap] to turn ON the projector light.

To turn OFF the projector light, press and hold for 3-4 seconds.

Adjusting the Projector's Light Color and Brightness

Tap [tap] to cycle through the color light options (White → Yellow → Blue → Multicolor).

White Noise & Sound Spa Sounds Play/Stop

With the Led Starlight Projector turned on, tap [tap] to PLAY the last sound played. Each tap selects the next of 15 total sounds.

To STOP the audio, press and hold for 3-4 seconds.

Adjusting the Volume

Tap [volume-down] to lower the volume gradually.

Tap [volume-up] again to increase the volume gradually.

Smart Memory

Turning on the LED Starlight Projector by tapping [tap] will start the last light, sound, and volume settings selected.

Setting The Timer

We recommend supervised use both in timer and continuous mode. We strongly recommend using the timer when you use the unit in the evening or overnight.

With the LED Starlight Projector on, slide the switch between ∞ (Continuous Play), 1HR, 4HR, or 8HR and set the projector light and sounds to your preference. The Timer Switch on the side of the unit will continuously play lights, sounds, and projector or turn them off automatically after a set amount of time, based on your setting.

Powering the Unit: 2 Power Options

Endless Power

Uses the included USB power cable. Plug the cable into the "DC 5V" jack on the back of the Led Starlight Projector. Then, plug the USB end of the power cable into a USB power source such as a computer or USB charging adapter (not included).

[Diagram Description: Shows a USB cable connected to the projector's DC 5V port and the other end plugged into a USB power source.]

Cordless

Requires three (3) AA batteries (not included).

To use or replace batteries, use a [Phillips screwdriver] to remove the screw and unlatch the battery door on the bottom of the unit.

1. Remove the battery door and insert three (3) AA batteries (not included) into the battery compartment.
2. Replace the battery door and replace and tighten the screw on the battery door latch to reattach the door.

[Diagram Description: Shows the battery compartment with a latch screw and space for three AA batteries.]

Care and Maintenance

• Always unplug the unit before cleaning.
• Use a slightly damp cloth to clean the unit.

Danger/Warning

Use this unit only for its intended use as described in this manual to reduce the risk of burns, fire, electric shock, or injury to persons:

• Close supervision is necessary when disabled persons use this unit, and close supervision is necessary when using the projector near children or disabled persons.
• Never place the unit or its cord within reach of children or disabled persons.
• Always unplug the unit from the electrical supply outlet when not in use.
• Do not place speakers close to your ears. It may cause hearing damage.
• Do not look directly at the light projected through the star dome.
• Do not attempt to repair, modify, dismantle the product.
• Designed for indoor use. Do not use the unit outdoors and avoid rain or moisture that can damage the projector.
• Never operate this unit if it has a damaged cord or plug, if it is not working properly, if it has been dropped or damaged, or dropped into water. Return the unit to Zadro, Inc. for examination and repair.
• Never drop or insert any object into any opening.
• Keep the cord away from damp or heated surfaces.

AC Adapter & Power Cord

Only use a DC to USB Power Cord approved by Zadro Products for use with this unit. The use of any other DC to USB Power Cord will void the warranty and can damage the unit. Use a standard AC USB Power Adapter or USB Power Source.

To order, visit our website at www.ZADROINC.com or call customer service at (800) 468-4348.

FCC Information

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.

WARNING: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This unit generates, uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try and correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

This CLASS(B) DIGITAL APPARATUS complies with CANADIAN ICES-3 (B)/NMB-3(B).

1 Year Limited Warranty

Zadro products include a 1 Year limited warranty from date of purchase against defects in materials and workmanship. This warranty does not include damage to the product as a result of misuse or accident.

Should your product become defective during the warranty period, Zadro, Inc.™ will repair or replace (at its sole discretion) your product, at no charge. However, you are responsible for properly packing your product and any applicable shipping charges to Zadro, Inc.™

Please contact Customer Service at 800-468-4348, 714-892-9200 or email customersupport@zadroinc.com on how to obtain an RMA (return authorization number). Please have available and/or include a copy of your receipt, model number (STARPRO4C) and the issue you are experiencing with your product.

CUSTOMERS OUTSIDE THE UNITED STATES OF AMERICA, PLEASE CONTACT THE RETAILER OF PURCHASE DIRECTLY TO RESOLVE ANY PRODUCT WARRANTY ISSUES.

Any product returned for preference is subject to a 20% restocking fee of the product and no shipping charges will be refunded.

Zadro, Inc.™ shall not be liable for any incidental or consequential damages arising out of defects in this product, whether or not caused by its negligence. Some states do not allow the exclusion or limitation of incidental or consequential damages or allow limitations on how long an implied warranty lasts, so the above limitations or exclusions may not apply to you. This warranty gives you specific legal rights and you may also have other rights, which vary from state to state.

Thank you for your purchase! Visit us online to leave reviews and see other great products at www.zadroinc.com.

© Zadro, Inc.