Anker MagGo Power Bank (10K, Slim)

Important Safety Instructions

When using this product, basic precautions should always be followed:

1. Use of a power supply or charger not recommended or sold by the product manufacturer may result in a risk of fire or personal injury.
2. Operating temperature should be between 0°C to 35°C / 32°F to 95°F.
3. Do not disassemble this product. Take it to a qualified service person when service or repair is required. Incorrect reassembly may result in a risk of fire or personal injury.
4. CAUTION: Risk of explosion if the battery is replaced by an incorrect type.
5. To reduce the risk of injury, close supervision is necessary when the product is used near children.
6. Do not expose power bank to rain or snow.
7. Do not use the power bank that is damaged or modified. Damaged or modified batteries may exhibit unpredictable behavior resulting in fire, explosion or risk of injury.
8. Do not expose a power pack to fire or excessive temperature. Exposure to fire or temperature above 100°C may cause explosion.
9. Switch off, deactivate or unplug the power bank when not in use.
10. CAUTION: Risk of Fire and Burns. Do Not Open, Crush or Incinerate. Follow Manufacturer's Instructions.

Compatibility Note: This product is not compatible with non-MagSafe phone cases, such as Otterbox Defender cases. Do not use an adapter with an output of 5V/1A (5W) or less. High temperatures will reduce charging speed and restrict power; it is recommended to charge your device in environments with temperatures below 25°C / 77°F.

FCC Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation.

Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio / TV technician for help.

Radiation Exposure Statement

This equipment complies with FCC Radiation exposure limits set forth for an uncontrolled environment. This equipment can be used in portable exposure condition.

IC Statement

This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada's licence-exempt RSS(s). Operation is subject to the following two conditions: 1. This device may not cause interference. 2. This device must accept any interference, including interference that may cause undesired operation of the device.

L'émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d'Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes: 1. L'appareil ne doit pas produire de brouillage; 2. L'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.

RF Exposure Statement

IC RF exposure statement: This equipment complies with IC Radiation exposure limits set forth for an uncontrolled environment. This equipment can be used in portable exposure condition.

IC RF déclaration d'exposition: Cet équipement est conforme aux limites d'exposition aux radiations IC établies pour un environnement non contrôlé. Cet équipement peut être utilisé dans des conditions d'exposition portables.

Declaration of Conformity

This product complies with the radio interference requirements of the European Community. Hereby, Anker Innovations Limited declares that this product is in compliance with Directives 2014/53/EU & 2011/65/EU. The full text of the EU declaration of conformity is available at the following internet address: https://support.anker.com/s/articleRecommend?otherType=Anker_EN_Extemal_Manual_and_Download&secondType=doc

This symbol indicates that this product shall not be treated as household waste. Instead, it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment.

The following importers are the responsible parties (contract for EU and UK matters):

• Anker Innovations Deutschland GmbH, Georg-Muche-Strasse 3, 80807 Munich, Germany
• Anker Technology (UK) Ltd, GNR8, 49 Clarendon Road, Watford, Hertfordshire, WD17 1HP, United Kingdom

Technical Specifications:

• (a) frequency band(s) in which the radio equipment operates: 111~205KHz | 360KHz (for EU / UK only)
• (b) maximum radio-frequency power transmitted in the frequency band(s) in which the radio equipment operates: Radiated H-Field -16.17dBuA/m @10m | -18.89dBuA/m @10m

Contact Information

• support@anker.com
• support.mea@anker.com (For Middle East and Africa Only)
• (US/CA) +1 (800) 988 7973
• (UK) +44 (0) 1604 936200
• (DE) +49 (0) 69 9579 7960
• (UAE) +971 8000320817
• (KSA) +966 8008500030
• (Kuwait) +965 22069086
• (Egypt) +20 8000000826
• (TR) +90 (850) 4601414
• (RU) +8 (800) 511-86-23
• (India) +000-8000-504-414
• ( 中国 ) +86 400 0550 036
• ( 日本 ) 03 4455 7823
• ( 한국 ) +82 02-1661-9246

Manufacturer Information

Anker Innovations Limited, Unit 56, 8th Floor, Tower 2, Admiralty Centre, 18 Harcourt Road, Hong Kong

Additional Resources

For tutorial videos, FAQs, manuals, and more information, please visit: https://support.anker.com