Aigostar LED String Lights

I. Product Description

These LED string lights offer 8 dynamic functions, controllable via a single button. The lights can be set to a timer mode, where they stay on for 6 hours and off for 18 hours, repeating daily. This timer function is activated by pressing and holding the button for 3 seconds until a green light appears, and deactivated by pressing and holding the button again until the green light turns off. The lights will automatically resume the last set function after a power interruption.

Function Modes:

• Combination: Automatic continuous change between various functions.
• In Waves: Automatic change forwards and backwards (two speed settings).
• Sequential: Automatic change (four speed settings).
• Slo-Glo: A single light fades (three speed settings).
• Chasing/Flash: Automatic change of star flashing.
• Slow Fade: Two lights fade simultaneously (three speed settings).
• Twinkle/Flash: Automatic twinkling.
• Steady On: The LED is always illuminated.

II. Installation

Connect the end connector of the light string to the power controller connector and tighten the knob to secure the connection. Ensure the connection points are accessible.

Diagram showing the connection of the light string end connector to the power controller.

III. Warnings

• Do not connect the string light to the power supply while it is still in the packaging.
• Use only the provided transformer for the product. Do not connect this string light to the circuit of other string lights.
• Hang the lights out of the reach of children to prevent choking hazards.
• Dispose of the product in accordance with municipal waste regulations at the end of its service life.
• The lamps (LEDs) are not replaceable.
• Warning: Risk of electric shock if lamps are broken or missing.
• The light source of this luminaire is not replaceable. When the light source reaches the end of its life, the entire luminaire must be replaced.