AGPTEK H7 Car LED Bulbs User Manual
Specifications
| Model | H7 |
|---|---|
| Watt/Voltage | 30W/12V |
| Application | For car & motorbike |
| Bulb base | PX26d |
Important Tips
- During installation, do not touch the LED chipset.
- When replacing, please replace a pair of LED bulbs at the same time to ensure the best lighting effect and driving safety.
- If you find that the car lights' brightness are dim, please replace them with new high-quality lights in time. This product has passed ECE certification and complies with EU applicable laws on road traffic. If you have any problem about this product, please feel free to contact us at support@agptek.com.
Installation
Step 1
Open the hood, and then open the dust cover.
[Image Description: A car headlight assembly is shown with the dust cover being opened to access the bulb housing.]
Step 2
Find and remove the original halogen bulbs.
[Image Description: A hand is shown carefully removing an old halogen bulb from the car headlight socket.]
Step 3
Move out the chuck of the LED bulb.
[Image Description: A hand is shown detaching the electrical connector or 'chuck' from the base of the new LED bulb.]
Step 4
Install the LED chuck into the pedestal.
[Image Description: The electrical connector ('chuck') of the LED bulb is being inserted into the corresponding socket or pedestal within the headlight assembly.]
Step 5
Install the LED bulb and adjust its position.
[Image Description: The LED bulb is being placed into the headlight socket and adjusted for proper alignment and fit.]
Step 6
Connect the plug to the original car lamp connector. Then, fix the dust cover.
[Image Description: The LED bulb's connector is plugged into the vehicle's original wiring harness connector. The dust cover is then secured over the bulb housing.]
IMPORTANT NOTE: When you plug the bulbs into the socket but they do not light up, just rotate the plug 180 degrees and then insert it.
