FIBARO Smoke Sensor
Z-Wave Protocol Implementation Conformance Statement
General Information
- Product Identifier: FGSD-002
- Brand Name: FIBARO
- Product Version: HW: 2 FW: 3.03:03.03
- Z-Wave Certification #: ZC10-18025999
Product Features
- Supported Notification Types: Smoke Alarm
- Battery Type: CR123A
- Battery Quantity: 1
- Sensors: Smoke Density
- Color: White
Z-Wave Product Information
- Supports Z-Wave Beaming Technology?: No
- Supports Z-Wave Network Security?: Yes
- Supports Z-Wave AES-128 Security S0?: Yes
- Supports Security S2?: No
- SmartStart Compatible?: No
Z-Wave Technical Information
- Z-Wave Frequency: CEPT (Europe)
- Z-Wave Product ID: 0x1003
- Z-Wave Product Type: 0x0C02
- Z-Wave Hardware Platform: ZM5202
- Z-Wave Development Kit Version: 6.51.07
- Z-Wave Library Type: Enhanced 232 Slave
- Z-Wave Device Type / Role Type: Notification Sensor / Reporting Sleeping Slave
Association Group Information
| Group # / Max Nodes | Description |
|---|---|
| 1 / 1 | 1st group - Lifeline. Reporting device state. Only one device - Z-Wave network controller may be set in this group. It's not recommended to modify this association group. |
| 2 / 5 | 2nd group - Smoke Alarm. Sending the BASIC SET control command once smoke is detected. Its value may be modified in advanced parameters (see section XVI). Group may control up to five on/off devices. |
| 3 / 5 | 3rd group - Tamper. Sending the notification NOTIFICATION REPORT (TYPE = BURGLAR, EVENT = PRODUCT COVERING REMOVED) to associated devices once casing opening is detected. Up to five devices supporting casing opening command (NOTIFICATION REPORT) may be included in this group. |
| 4 / 5 | 4th group – Smoke Alarm. Sending the notification SENSOR ALARM REPORT (TYPE = SMOKE ALARM) to associated devices once smoke is detected. Up to five devices supporting SMOKE ALARM command may be included in this group |
| 5 / 5 | 5th group - Tamper. Sending SENSOR ALARM REPORT notification (TYPE = GENERAL) to associated devices once casing opening is detected. Up to five devices supporting SENSOR ALARM REPORT command may be included in this group. |
Supported Command Classes (19):
- Application Status
- Association V2
- Battery
- CRC16 Encapsulation
- Firmware Update Meta-Data V3
- Multi Channel Association V2
- Powerlevel
- Sensor Alarm
- Version V2
- Z-Wave Plus Info V2
- Association Group Info
- Basic
- Configuration
- Device Reset Locally
- Manufacturer Specific V2
- Notification V5
- Security S0
- Sensor Multilevel V8
- Wake Up V2
Controlled Command Classes (1):
- Basic
