Westfalia Electric Hedge Trimmer 710 W

Welcome

Please familiarize yourself with the proper usage of the unit by reading and following each chapter of this manual, in the order presented. Keep these operating instructions for further reference. This operating instruction contains important details for handling the unit. Please pass the manual on along with the unit if it is handed over to a third party! Please also read all safety instructions! These instructions will make it easier for you to handle the unit and help prevent misunderstandings and possible damage or injury.

Overview

The Electric Hedge Trimmer 710 W features the following components:

• 1: Auxiliary Handle with Safety Switch
• 2: Release Switch
• 3: Handle with ON/OFF Switch
• 4: Cable Run
• 5: Hand Protection
• 6: Blade Bar
• 7: Blade Bar Protection

Diagram Description: A visual representation of the hedge trimmer showing the numbered parts: the main body containing the motor, the front auxiliary handle with a safety switch, the rear handle with the main power switch, the blade bar extending from the front, and the power cord with a cable strain relief.

Safety Notes

Important: Please read all safety instructions carefully to avoid malfunctions, damage, or physical injury.

• Ensure the mains voltage matches the unit's rating plate.
• This unit is not intended for use by persons with reduced physical, sensory, or mental capabilities.
• Keep bystanders out of the working area and do not leave the hedge trimmer unattended after use.
• Use the hedge trimmer only for its intended purpose: cutting leaves, bushes, shrubs, and hedges. Do not cut thick branches or similar material.
• Do not use near flammable liquids or gases.
• The unit is not designed for continuous, professional use.
• Do not expose the hedge trimmer to rain. Do not operate in damp or wet conditions, or cut wet foliage. Do not work in the dark.
• Before use, check for damaged parts and do not use if damage is detected.
• Operate with the hand protection (5) attached. Hold the trimmer firmly with both hands on the handles.
• Wear suitable clothing: safety glasses ?, safety gloves ?, and hearing protection ?.
• Ensure a stable stance. If using ladders or scaffolds, ensure they are stable and cannot topple. Maintain balance while cutting.
• Keep the power cord away from the cutting area, oil, heat, and sharp edges.
• Never carry the trimmer by the cord. Always grasp the plug to unplug.
• Always fit the blade protection when carrying or storing the trimmer.
• Do not pull the trimmer by the cord; ensure it cannot get caught.
• Always switch off and disconnect from power mains when cleaning, maintaining, or not in use.
• Use only approved outdoor extension cables (e.g., H07RN-F 3x1.5 mm²). Consult an electrician if unsure.
• Use a socket with an RCD (Residual Current Device) with a rating < 30 mA. This is obligatory in Switzerland.
• The blades are very sharp. Do not touch the blades during operation. Keep fingers, hair, clothing, and other objects away from the blade bar.
• Do not attempt to remove cut material or hold material to be cut while the blades are running. Remove jammed material only when the unit is switched off and unplugged.
• Keep the blade bar sharp and clean. Replace defective or worn blades with original parts only.
• Do not force the trimmer; allow it to work at its designed rate. Take sufficient breaks.
• If the unit is damaged, do not use it. Have it repaired by a qualified professional or contact customer support. Do not attempt self-repair.

Warning Symbols:

⚠️ General Warning
? ↔️ ? Keep bystanders away
??️ Do not expose to rain
? Disconnect power before maintenance/if cord is damaged
? Wear eye protection
? Wear hearing protection
? Wear protective gloves
? Wear sturdy shoes
? Read instruction manual

Operation

Before First Use

Remove the hedge trimmer and accessories from packaging. Keep packaging materials away from children due to suffocation risk.

1. Form a loop with the extension cord and pass it through the opening in the handle.
2. Hook the extension cord onto the cable run (4).

Adjusting the Working Position

The motor housing can be rotated 90° in both directions, snapping into place at 45° and 90°. To rotate, push the release button (2) forward and turn the housing left or right until it audibly locks. Operation is not possible with the motor housing unlocked.

Operating the Trimmer

1. Connect the trimmer's plug to the extension cord and a grounded wall socket.
2. Remove the blade bar protection (7).
3. To start: Press and hold the auxiliary safety switch on the auxiliary handle (1), then press the ON/OFF switch on the handle (3).
4. Always hold the unit firmly with both hands: one on handle (3), the other on auxiliary handle (1).
5. To switch off, release both switches.
6. Before adjusting the angle of inclination, always disconnect from power mains.

Hints on Trimming Hedges

• Before cutting, remove thick branches or similar material. Ensure no small animals are hidden in bushes/hedges.
• Observe local rest periods to avoid disturbances.
• For significant trimming, cut in two passes.
• To achieve a straight cut, set the desired height and stretch a string along the hedge. Guide the blades at a 10°-15° angle to the hedge.
• Trim hedges in a trapezoidal shape, cutting from bottom to top.
• Round the top edges of the hedge.
• Finally, trim the bottom edges.
• Dispose of cut materials properly.

Maintenance and Cleaning

• Oil the blade bar with suitable spray after cleaning and before next use.
• Always disconnect from power mains before cleaning or maintenance.
• Remove dirt from the blade bar with a scrubbing brush or small brush.
• Do not use harsh detergents or aggressive chemicals on the housing. Use a lightly moistened cloth. Clean ventilation slots with a soft brush.
• Store the hedge trimmer in a dry, dust-free, and frost-protected place.
• When not in use or storing, always slide the blade bar protection over the blade bar.

Technical Data

Declaration of Conformity

Westfalia Werkzeugcompany declares that the Electric Hedge Trimmer 710 W (Article No. 87 39 02) complies with essential requirements of European Directives, including:

• 2011/65/EU (RoHS)
• 2014/30/EU (EMC)
• 2006/42/EC (Machinery)
• 2000/14/EC (Outdoor Directive)

Technical documentation is available at the QA department of Westfalia Werkzeugcompany.

Signed by Thomas Klingbeil, Quality Representative, dated October 23, 2020.

Customer Service and Disposal

Customer Service Contact Information:

Germany

Westfalia
Werkzeugstraße 1
D-58093 Hagen
Phone: (0180) 5 30 31 32
Fax: (0180) 5 30 31 30
Internet: www.westfalia.de

Austria

Westfalia
Moosham 31
A-4943 Geinberg OÖ
Phone: (07723) 4 27 59 54
Fax: (07723) 4 27 59 23
Internet: www.westfalia-versand.at

Switzerland

Westfalia
Wydenhof 3a
CH-3422 Kirchberg (BE)
Phone: (034) 4 13 80 00
Fax: (034) 4 13 80 01
Internet: www.westfalia-versand.ch

Disposal Information

Please help avoid waste. Many components of this article consist of valuable, recyclable materials. Do not dispose of in household waste. Check with your local council for recycling facilities.