DRINK MACHINE

I EXPLOSION DIAGRAM

An exploded view illustration of the D25 Cold Drink Dispenser, showing various components labeled with numbers. The illustration depicts the dispenser disassembled into its constituent parts, allowing for identification of each component.

II SAFETY PRECAUTIONS

All safety regulations, local codes, and instructions that appear in the manual or on the equipment must be observed to ensure personal safety and to prevent damage to the machine. If equipment is used in a manner not specified by the manufacturer, the protection covered by the warranty will become null and void.

ICONS FOUND THROUGHOUT THIS DOCUMENT AND WHAT THEY REPRESENT

WARNING

⚠️ Risk of harm to the operator or machine if performed incorrectly.

CAUTION

❗ Informs the operator of a task that may lead to harm if instructions are not followed.

IMPORTANT

❗ Represents an extremely important step or note the user must be aware of.

NOTE

? Non-hazardous, informational text.

III UNPACKING & SETUP

WARNING

⚠️ Unpalletizing requires lifting. Two or more personnel should remove the machine from its packaging and place it in its final operating location. Failure to do so may result in severe injury or damage.

UNPALLETIZE MACHINE

1. To remove all sides and cover of shipping box, unfold all tabs on the shipping box from their closed position to the open position using a flat-head screwdriver, and a hammer if needed.
2. Remove plastic wrapping from around the machine.
3. Being careful not to scratch or dent the machine panels, remove both side panels with a phillips-head electric screw driver.
4. On the bottom of the machine there are 2 stabilizing bolts securing the machine to the bottom of the shipping pallet/box. Using a #12 wrench and a #12 ratchet carefully remove both bolts.
5. Reattach both side panels using the phillips-head electric screw driver.

CAUTION

❗ The machine is designed to operate in normal ambient temperatures of 60-75°F. Operating in higher ambient temperatures will result in less than optimal performance.

6. Prepare the area where the machine will be placed.

7. Place the machine in its final location according to the Installation Requirements.

D25 DRINK MACHINE

"Bubblers" are much more than just a cold drink dispenser, as these circulate the drink from the bottom to the top of the bowl using a pump so that the drink cascades down all sides of the bowl for great visual merchandising.

The bowls are made of polycarbonate for easy cleaning and long life.

The machine design is easy to use (just pour in the mix and turn on the power).

Features

• Self-contained air cooled countertop model
• Stainless steel allow easier cleaning and less maintenance
• Super-strong, virtually unbreakable polycarbonate bowls and covers give lasting durability
• 1 motor per bowl, 1 switch per bowl - Each bowl operates independently of each other.
• Large 9.5 gallon, dishwasher safe, plastic bowls.

*The D25 is manufactured for Donper USA by a third party.

SPEC SHEETS

Diagrams showing the side, front, and top views of the D25 dispenser with key dimensions indicated in inches.

Side View: 15.25 inches

Front View: 28.75 inches (Height)

Top View: 19.75 inches (Width)

Distributed By: Donper USA