Miele Fully Integrated Dishwasher Installation Diagram

General Information

To prevent accidents and machine damage, read the Operating/Installation and Important Safety Instructions before installation or use.

Fittings supplied depend on the model. Optional accessories may be required.

Ensure all characters are verified for accuracy.

Required Dimensions

• Standard Height Models: Minimum undercounter height of 32 7/16" (835 mm) if the intake hose is coiled under the dishwasher.
• XXL Height Models: Minimum undercounter height of 34 13/16" (885 mm) if the intake hose is coiled under the dishwasher.
• Ensure the hose is free of kinks and can move freely after installation.
• Do not place the hose or power cord near a heat source or expose them to corrosive substances.
• Warning: Damage to the hose or power cord could cause electrical shock or water damage!
• Cabinet dimensions:
• Width: 23 1/4" (590 mm) to 23 7/16" (595 mm)
• Height: 32 1/16" (815 mm) to 34 5/8" (880 mm) for standard models, 33 11/16" (855 mm) to 36 1/4" (920 mm) for XXL models.
• Depth: Minimum 22 7/16" (570 mm)

Installation Steps

The following steps outline the general installation process. Refer to the diagrams for specific details.

1. Prepare the cabinet opening according to the specified dimensions.
2. Install any necessary mounting brackets or supports.
3. Attach the front panel to the dishwasher door.
4. Connect the water intake hose and drain hose. Ensure proper routing to avoid kinks.
5. Connect the electrical supply. Verify voltage, rated load, and fuse rating.
6. Slide the dishwasher into the prepared cabinet opening.
7. Secure the dishwasher in place using the provided fittings.
8. Adjust the leveling feet to ensure the dishwasher is stable and level.
9. Warning: Do not use a cordless screwdriver, as it may cause damage.
10. Warning: Sharp edges can damage the power cord and hoses. If cabinet panels have sharp edges, round them off with sandpaper or use Miele-approved edge protection for metal panels.
11. Adjust the door springs equally on both sides after securing the front panel.
12. If the water drain hose connection is lower than the lower basket roller path, raise the drain hose with a bend above this level.

Safety Precautions

• Risk of damage or fire hazard. Check voltage, rated load, and fuse rating.
• Risk of cutting hazard. Handle with care during installation.
• Ensure the intake hose is not kinked or crushed.
• Do not sit the dishwasher on the intake hose.
• Keep power cords and hoses away from heat sources and corrosive substances.

Tools and Parts

Tools required depend on the model. Fittings supplied depend on the model.

Commonly used parts include screws of various sizes (e.g., 4x15, 4x20, 4x27) and leveling feet.