Case Overview
Rear View
Diagram showing the rear of the computer case, indicating ventilation, expansion slots, and the power supply unit (PSU) mounting area.
Left View (Open)
Diagram showing the internal layout of the computer case with the side panel removed. It highlights the motherboard mounting tray, drive bays (labeled 1 through 6), and space for cable management.
Installation Steps
1. Install PSU
Description: Install the Power Supply Unit (PSU) into its designated bay. Typically secured with screws (indicated as X4 in the diagram).
2. Install Motherboard
Description: Mount the motherboard onto the standoffs inside the case. Secure the motherboard using screws.
3. Install ODD
Description: Install an Optical Disk Drive (ODD) into the appropriate drive bay, usually a 5.25-inch bay.
4. Install 2.5" SSD
Description: Install a 2.5-inch Solid State Drive (SSD) into a compatible drive bay or mounting bracket.
5. Install 3.5" HDD
Description: Install a 3.5-inch Hard Disk Drive (HDD) into its designated bay, secured with screws (indicated as X4 in the diagram).
Cable Connection for Front I/O
Fpanel Connector
This connector block interfaces case buttons and LEDs with the motherboard. It includes:
- Power SW (Power Switch)
- Reset SW (Reset Switch)
- HDD LED (Hard Drive Activity Light)
- HDD LED- (Negative terminal for HDD LED)
- HDD LED+ (Positive terminal for HDD LED)
MB Connector
This section shows other front panel connectors, including:
- USB connector
- HD AUDIO connector
Accessory Bag Contents
The accessory bag typically contains the following hardware:
- Motherboard Standoffs
- Screws: Motherboard Screw, SSD Screw, ODD Screw
- Screws: PSU Screw, PCI Screw
- 3.5" HDD Screw
