Cleaning and Disinfection Guide

General Precautions

Before cleaning or disinfecting the Artis System, ensure that the system is disconnected from the power supply and switched off. Wear gloves during cleaning and disinfecting the system.

Prior to Examination

Prior to each examination, clean all parts that come into contact with the patient to prevent contamination of the Artis System.

CAUTION: Risk of Electrical Hazard or Damage to the System

• Use only substances for cleaning and disinfection which are recommended.
• Do not let cleaning liquids seep into the openings of the system, e.g., air openings, gaps between covers.
• Observe the following cleaning and disinfection instructions.

Cleaning and Disinfecting the Artis System Parts

• Before cleaning the system, shut down the system properly.
• Keep the ventilation slots of all components unobstructed.
• Dust deposited on moving parts can impair unit movements.
• Regularly clean the dust off all rails and joints etc.
• The adhesive capacity of the Velcro tapes will be reduced if contaminated.
• Remove any contamination using a plastic comb.
• Use a lukewarm detergent solution and a soft cloth to remove slight contamination.
• Remove major contamination first with a cloth soaked in alcohol, then wipe off with clear water.
• Remove blood spots best of all with cold water.
• Remove contrast medium spots best of all with warm water.
• After using disinfectants, always wipe off with clear water.

Recommended Active Ingredient Classes for Artis System

Products Not Recommended for Use

• All alcohol-based products
• All chlorine-releasing products
• Benzine / phenole-based products
• Products: Banicide Advanced, Wavicide, Terralin, Cidex OPA

Note:

• Some substances contained in disinfectants are known to be hazardous to health. Their concentration in the air must not exceed the legally defined limit.
• Always follow the safety data sheets of the manufacturer which provide detailed information on the composition of the disinfectants.

Cleaning and Disinfecting the LC Displays

LC displays are very sensitive to mechanical damage. Avoid scratches, bumps, etc.

LC displays are very sensitive to liquids. Longer contact with liquids can cause discoloration or can leave calcium residue on the surface. Droplets that run down between the panel and the frame can cause damage or total failure of the panel!

• If possible, immediately clean any droplets of liquid.
• If a cleaning agent is sprayed directly on the display surface, make sure that any droplets that run down are wiped off with a microfiber cloth before they reach the edge of the panel.
• If the front of the panel is soiled, clean it with a microfiber cloth and, if necessary, with a glass cleaning agent. Clean housing parts with a cleaning agent for plastics only.
• In the case of contaminated panel front, clean with a microfiber cloth and, if necessary, with a cleaning agent.
• Clean the housing components only with the recommended agents.

Recommended Active Ingredient Classes for LC Displays

Reference

Siemens Artis one, Artis zee, Artis Q and Q.zen Operator Manuals.