ILVE Cooker Hood

Information and advice

Specifications: 220-240V ~ 50Hz

In certain circumstances, electrical appliances may present a hazard.

• Ensure adequate ventilation of the room when the cooker hood is used simultaneously with appliances burning gas or other fuels.
• Do not check the status of the filters while the cooker hood is operating.
• Do not touch the light bulb within half an hour after appliance use.
• Do not flambé under the cooker hood.
• Avoid opening the gasometer when there is no pan on the stove, as this can damage the filters and create a fire hazard.
• Constantly monitor food frying to prevent overheated oil from becoming a fire hazard.
• Disconnect the electrical plug prior to any maintenance.
• Regulations concerning the discharge of air must be fulfilled.
• When the range hood and appliances supplied with energy other than electricity are simultaneously in operation, the negative pressure in the room must not exceed 4 Pa (4x10⁻² bar).
• This appliance is not intended for use by persons (including children) with reduced physical, sensory, or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
• Children should be supervised to ensure they do not play with the appliance.
• The range hood is intended to be installed over a hob having no more than four hob elements.
• Indoor use and household use only.
• When the appliance is not in use and before cleaning, unplug the appliance from the outlet.
• To protect against the risk of electrical shock, do not immerse the unit, cord, or plug in water or other liquid.
• Accessible parts may become hot when used with cooking appliances.
• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent, or similarly qualified persons to avoid a hazard.
• There is a fire risk if cleaning is not carried out in accordance with the instructions.
• Details concerning the method and frequency of cleaning are provided.
• The air must not be discharged into a flue that is used for exhausting fumes from appliances burning gas or other fuels.

Know your cooker hood

Please read these instructions before using your cooker hood.

Components:

• 1. 120mm to 125mm ducting adaptor
• 2. Outlet connection
• 3. Main body assembly
• 4. Motor assembly
• 5. Outside frame
• 6. Front panel
• 7. Telescopic board
• 8. Filter

Information: Congratulations on the purchase of your Cooker Hood, designed with superior features for your living. Before installing and/or using the cooker hood, carefully read all instructions.

Installation Steps

Step 1: Check the voltage and frequency given on the rating plate located on the inside of the hood.

Step 2: Install the hood no less than 600mm and no more than 750mm above the cooking surface.

Information: The air must not be discharged into a flue that is used for exhausting fumes from appliances burning gas or other fuels (not applicable to appliances that only discharge the air back into the room).

Step 3: Decide if you will use the hood in ducted or recirculating mode. Measure the dimensions of your cabinet and compare with the hood.

This hood can be used in either ducted or recirculating mode. It comes with a 40mm rail for ducted mode. If using in recirculating mode, remove the tape over the vent in the front of the unit.

Step 4: Ensure the power is turned off before beginning installation. Connect the universal hose, selecting the venting direction.

If you are using a duct, first push out the duct hole and fix the damper flap on the air outlet of the hoods.

Step 5: If installing with a duct, provide a hole for the duct using the provided template.

Step 6: According to Fig.4, ensure the correct position of the hoods on the cabinet. Use the stencil to drill four holes on the cabinet. Fix four expanding plugs and screws aimed at the four holes. Ensure the distance between the bottom of the machine and the cabinet on two sides is less than 2mm. Ensure there is no distance between the upside and the cabinet, and the gap to the back is not more than 10mm. The plug should be easy to touch for assembly.

Information: When drilling into the wall or ceiling, do not damage electrical wiring or other hidden utilities.

Step 7: Connect the hose (not supplied) with the air duct. This hood comes with an adaptor for flexibility in duct sizes, but the duct should not be less than 125 mm diameter.

Step 8: Vertical flue is a common installation method. If your kitchen has an attic space above, the ducting may run through the cupboard and attic to a roof cap.

Information: The air must not be discharged into a flue that is used for exhausting fumes from appliances burning gas or other fuels.

Controls

Lamp switch: Controls the hood light.

Motor switch: Controls the fan speed.

Operation: The hood turns on when you pull out the slide. The lamp switch is on the left side of the hood. The fan switch is on the right side. The fan has 3 settings: off, low speed, and high speed.

Information: Do not touch the light bulb within half an hour after appliance use. The lamp shall not be covered with thermal insulation or other material.

Replacing Lamp

1. Switch off the hoods and remove the plug.
2. Pull out the telescopic board, take off the lamp, and remove the connection unit.
3. Replace with a new lamp, turning in a clockwise direction, and fit the connection unit.
4. Lamps must be replaced by the manufacturer, its service agent, or similarly qualified persons to avoid a hazard.

Information: There is a fire risk if cleaning is not carried out in accordance with the instructions.

Important Safety Information

• The appliance is not intended for use by young children or infirm persons unless they have been adequately supervised by a responsible person to ensure they can use the appliance safely.
• Young children should be supervised to ensure they do not play with the appliance.

The manufacturer declines all responsibility if the foregoing recommendations and instructions regarding installation, maintenance, and use are not observed and respected when using the cooker hood.

Technical Specifications (Diagram)

Dimensions:

• Height: 163mm
• Depth: 280mm
• Width: 598mm/898mm
• Ducting adaptor diameter: 103mm
• Body height: 139mm
• Front panel height: 42mm
• Rear panel height: 48mm
• Telescopic board depth: 282mm
• Telescopic board adjustment: 305mm - 460mm
• Front panel extension: 20mm
• Main body length: 503mm/803mm
• Ventilation outlet diameter: 103mm