User Manual for ThermELC models including: Te-02, Multi-Use USB Temp Data Logger, Te-02 Multi-Use USB Temp Data Logger, Data Logger, Temp Data Logger, Logger
Multi-Use USB Temp Data Logger User Manual 1 Product Introduction The device is mainly used to monitor the temperature of food, medicine, and other products during storage and transportation. After recording, insert it into the USB port of PC, it will automatically generate reports without any driver. Main Features Multi-use temperature measuring and recording Widely measuring range, high accuracy and large data memory Statistics available on LCD screen No software needed to generate PDF and CSV temperature report Parameter programmable by configure software 2 Specification Item Parameter Temp Scale or Temp Accuracy ±0.5(-20 ~ +40), ±1.0(other) Temp Range -30 ~ 60 Resolution 0.1 Capacity 32,000 readings Startup Mode Button or software Interval Optional Default: 10 mins Start Delay Optional Default: 30 mins Alarm Delay Optional Default: 10 mins Alarm Range Optional Default: <2 or >8 Shelf Life 1 year (replaceable) Report Automatic PDF and CSV Time Zone UTC +0:00 (Default) Dimensions 83mm*36mm*14mm Weight 23g 3 How to use data was marked successfully. the " " displays on a. Start Recording (Note: One record interval can mark one the screen, Press and hold the time only, the logger can mark 6 times in indicating stopping " " button for more one recording trip. Under status of start recording delay, the mark operation is disabled.) successfully. than 3s until that the c. Page Turning (Note: If the logger " OK" light is on and the " " or "WAIT" Shortly press " " to is stopped during the status of start delay, switch to different a PDF report generated when inserted displays on the screen, which indicates display interface. The into PC but without data.) the logger is started. interfaces shown in e. Get Report b. Mark sequence are When the device is respectively: recording, press and hold the " " Real-time Temperature LOG MARK Temperature Upper Limit button for more than Temperature Lower Limit. 3s, and the screen will switch to the "MARK" interface. The number of "MARK" will increase by one, indicating d. Stop Recording After recording, connect the device with Press and hold the " " button for more USB port of PC, it will automatically than 3s until the "ALARM" light is on, and generate PDF and CSV report. 4 5 6 f. Configure The Device Before start using the device, you also can connect it with computer, and use configure software to programme it. Note: a. If the device is used for the first time or after re-configuration, the real-time temperature interface will be the initialization interface. b. Real-time temperature interface is update every 10s. Real-time temp interface LCD Display Instruction Initialization Above upper limits Log interface Mark interface 7 8 Upper limit Lower limit WAIT ×" " and "" light ×" " and "" light Data logger is recording Data logger has stopped recording Data logger is in the status of start delay Temperature is within the limited range Measured temperature exceeds its temperature upper limit Temperature exceeds its temperature lower limit 9 Battery Replacement Battery Status Indication 4. Never dismantle the battery. Do not 1. Turn the battery cover counterclockwise to open it. (Opened status) Battery Capacity Full Good remove it if the logger is running. 5. Replace old battery with a new CR2032 button cell with the negative inward. Medium Low(please replace 2. Put in a new CR2032 button battery, batery) with the negative inward. Precautions 1. Please read the manual carefully before using the logger. 2. It is recommended to check the 3. Turn the battery cover clockwise to battery status before restarting the logger close it. to ensure that the remaining battery capacity could finish the recording task. (Closed status) 3. The LCD screen will be off after 10 seconds of inactivity. Please press the " " button to lighten it. 10 11 12WPS 文字