User Manual for Wortth home models including: FM-62MB-88MB Flushmount Fixture, FM-62MB-88MB, Flushmount Fixture, Fixture

black and white copy-r

To Ensure Canopy is Flush to Ceiling

1 day ago — To Install Fixture. Insert the metal springs into the recessed can until the metal teeth on the edges of the springs catcthes onto to.

• Google Docs
• Google Drive
• Download [pdf]
• Download Optimized



File Info : application/pdf, 2 Pages, 1.48MB

Document Document

To Ensure Canopy is Flush to Ceiling:
The patent pending metal springs uniquely have saw-toothed edges at the ends. When positioned correctly, it grips to the sides of the recessed can, securely holding the fixture in place. While pushing canopy flush to the ceiling, canopy may need to be rotated slightly to make sure the metal teeth grips onto the sides of recessed can when canopy is flush to ceiling.
To Straighten Fixture:
If necessary turn and manipulate canopy. Or make sure stem and socket cup ring is threaded on straight. If needed, loosen stem and socket ring and re-tighten onto socket to adjust shade position.
To Detach Fixture from Recessed Can: DO NOT use excessive force to pull down flushmount from the
ceiling as entire recessed could be pulled out if springs are not loosened first. With one hand, use wedge tool to pry edge of the canopy from the ceiling while firmly pulling and twisting (if needed) flushmount with other hand. This will flex the springs horizontally and loosen their grip, allowing flushmount to be pulled down.
Wedge Tool

4. To Install Fixture
Insert the metal springs into the recessed can until the metal teeth on the edges of the springs catcthes onto to the walls of the recessed can.Tuck all the wires into the can prior to covering the entire recessed opening with the fixture canopy.
5. To A ach Shade to Semi-Flushmount
Semi-Flushmount having sockets usually have accompanying shades. Mount shades onto fixture by letting socket pass through center opening and threading on decorative socket rings to socket. Make sure rings thread on evenly and catch the socket threadings.

Connector Spring Clips
Socket Cup Ring

FOR USE WITH INCANDESCENT RECESSED NON-IC OR IC LUMINAIRES
SUITABLE FOR USE WITH LUMINAIRES WITH 5INCH/6INCH DIAMETER LAMP COMPARTMENT
WARNING  RISK OF FIRE OR ELECTRIC SHOCK. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
WARNING Risk of fire or electric shock. Install this kit only in luminaires that have the construction features and dimensions shown in the photographs and/or drawings.
Do not make or alter any open holes in an enclosure of wiring or electrical components during kit installation.
WARNING To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp objects.
Installers should examine all parts that are not intended to be replaced by the retrofit kit for damage and replace any damaged parts prior to installation of the retrofit kit.
WARNING  Risk of fire. Input ratings may need to be determined based on any configuration(s) permitted by the installation instructions. Regardless of the configuration(s) of the retrofit kit, the input ratings of the overall retrofit kit shall not exceed the marked input ratings of the host luminaire.
This product is rated for damp location. Any installation in outdoor surrounding requires covered porch for installation and far enough distance away from exposure to rain or water spray.