Westinghouse WRG950CGS Rangehood: Technical Overview
This document provides technical details for the Westinghouse WRG950CGS rangehood, including an exploded view of the glass canopy assembly and the electrical circuit diagram.
EX. VIEW DRAWING 5661: GLASS CANOPY COMPLETE ASSEMBLY
The following is a list of components shown in the exploded view diagram of the glass canopy complete assembly for the WRG950CGS rangehood:
- Part 42: Top Vent/Cover
- Part 41: Side Panel
- Part 40: Side Panel
- Part 39: Side Panel
- Part 37: Base Assembly/Mounting Frame
- Part 27: Motor Mounting Bracket
- Part 26: Wiring Harness
- Part 28: Terminal Block
- Part 20: Canopy Frame
- Part 21: Glass Panel
- Part 22: Top Cover/Plate
- Part 19: Control Panel
- Part 18: Filter Clip
- Part 17: Filter
- Part 16: Light Cover
- Part 15: Light Fixture
- Part 14: Fan Housing
- Part 13: Fan Blade
- Part 12: Fan Motor Assembly
- Part 11: Fastener
- Part 10: Fastener
- Part 9: Fastener
- Part 8: Fastener
- Part 7: Fastener
- Part 6: Fastener
- Part 5: Fastener
- Part 4: Fastener
- Part 3: Mounting Bracket
- Part 2: Base Plate
- Part 1: Base Grille
- Part 23: Screw
- Part 24: Washer
- Part 25: Screw
EX. VIEW DRAWING 5684: CIRCUIT DIAGRAM
The circuit diagram illustrates the electrical connections for the WRG950CGS rangehood. It details the power supply, component connections, and wiring.
Power Input: The unit receives power from a ~220-240V/50Hz source via a Power Cord, with connections for Live (L) and Neutral (N). [arrow]
Components:
- Terminal Block: Connects the power cord to the internal wiring.
- PCB (Printed Circuit Board): Contains components labeled R1, R2, and L3.
- Motor (M): Likely the fan motor, connected to a Capacitor (C). [motor symbol], [capacitor symbol]
- RS Standard Switch: Features terminals labeled L, ST, 3, 2, 1 for controlling functions.
Wiring: The diagram shows connections using wires of various colors: Brown, Black, Red, Blue, Grey, and White. These wires connect to the terminal block, PCB, motor, and switch, linking to power terminals L, N, L1, and L2.
WARNING
IT IS ILLEGAL FOR PERSONS OTHER THAN LICENSED ELECTRICAL MECHANICS OR PERSONS AUTHORISED BY LEGISLATION TO WORK ON THE FIXED WIRING OF ANY ELECTRICAL INSTALLATION. PENALTIES FOR CONVICTION ARE SEVERE.
IMPORTANT SAFETY NOTICE
This diagram has been prepared for use by electrically qualified service technicians. The manufacturer cannot be held responsible for the interpretation of its service publications nor for any injury or damage that may occur in connection with their use.
