Miele Fully Integrated Dishwasher Installation Diagram

General Installation Notes

Dimensions: Minimum height for standard models is 815 mm (32 1/16"), and for XXL models is 855 mm (33 11/16"). Ensure adequate clearance for hoses.

Fittings: Supplied fittings depend on the model. Refer to the operating instructions for details.

Tools: Required tools vary by model.

Electrical Connection: Ensure correct voltage, rated load, and fuse rating. Warning: Risk of damage or fire hazard.

Water Inlet Hose: If the hose is coiled under the dishwasher, the undercounter height must be at least 835 mm (32 7/8") for standard models or 885 mm (34 13/16") for XXL models. Do not sit the dishwasher on the hose. Ensure the hose is free of kinks and can move freely. Avoid placing the hose or power cord near heat sources or corrosive substances. Warning: Damage to the hose or power cord can cause electrical shock or water damage.

Front Panel Installation: The minimum/maximum weight of the front panel is specified in the technical data on the Miele website. Ensure door springs are set equally on both sides after securing the front panel.

Adjusting Feet: Screw in the feet before moving the dishwasher.

Venting the Water Drainage: If the drainage connection is lower than the guide path for the lower basket rollers, the drainage system must be vented.

Sharp Edges: Be aware of sharp edges that can damage the power cord and hoses. If the cabinet dividing panel is wood, round off the edges of the cut-out with sandpaper.

Installation Steps

The following steps outline the general installation process. Specific details may vary by model.

• Step 1-3: Preparation and initial fitting of components.
• Step 4-7: Securing the dishwasher in the cabinet, including electrical and water connections. Pay attention to warnings regarding pinch hazards and cutting hazards. Do not use a cordless screwdriver to avoid damage.
• Step 8-13: Detailed diagrams showing the placement and connection of various parts, including water inlet and drainage hoses, and electrical connections. Note the required diameter for the water connection (7/8" / 22 mm) and compression fitting (3/8").
• Step 14-19: Further steps for securing the appliance, including attaching the front panel and adjusting door springs.
• Step 20-25: Final adjustments and checks, including leveling the appliance using the adjustable feet and ensuring all connections are secure.
• Step 26-29: Diagrams illustrating the final placement and securing of the dishwasher, including specific measurements for width (590-597 mm) and depth.

Safety Warnings

• Risk of damage or fire hazard: Ensure correct electrical specifications.
• Risk of cutting hazard: Be cautious of sharp edges.
• Risk of pinching hazard: Be careful when positioning the appliance.
• Damage risk from cordless screwdriver: Use manual screwdrivers.
• Water damage risk: Ensure hoses are properly connected and protected.