Ashley Furniture A4000075 Assembly Instructions
Model Number: A4000075
Important Safety Notice
READ CAREFULLY BEFORE BEGINNING ASSEMBLY!
- Always use proper tools.
- Follow the assembly steps in order. Do not skip any steps.
- Be sure to check all packing materials carefully for small parts that may have come loose inside the carton during shipment. If parts are missing, contact the retailer from which you purchased the product to obtain any missing parts. DO NOT USE SUBSTITUTE PARTS.
- Periodically check to ensure that all connectors (bolts, screws, etc.) are tight.
- Keep the instructions for future reference.
- Some assembly may involve attaching glass or mirrors. Be very careful handling the glass or mirrors, as severe injury may result if the glass or mirror breaks. Never handle large pieces of glass or mirrors by yourself.
- When assembling products that have electric cords (lamps, light, etc.), always (1) make sure the electrical cord is unplugged before assembly and (2) be careful not to twist the electrical cord during assembly.
- When assembling shelves or entertainment centers, do not stand on lower shelves in order to assemble upper shelves - use a step ladder.
- Do not stand on tables, including but not limited to, end tables, coffee tables, and dinner tables, as tables are not to support the weight of a person.
- Where assembly instructions state that the assembly requires two or more people, do not attempt by yourself as there is a risk of injury.
Disclaimer: ASHLEY FURNITURE INDUSTRIES, LLC DISCLAIMS ANY LIABILITY FOR DAMAGES OR INJURIES WHICH MAY OCCUR DUE TO FAILURE TO PROPERLY FOLLOW ASSEMBLY INSTRUCTIONS, PROPERLY ASSEMBLE THE PRODUCT, OR PROPERLY USE THE PRODUCT.
Note: YOUR UNIT MAY LOOK DIFFERENT IN APPEARANCE FROM THE ONE SHOWN IN THE ILLUSTRATIONS ON THIS INSTRUCTION SHEET.
Parts List
| Part Label | Description | Quantity |
|---|---|---|
| Ax1 | Side Panel | 1 |
| Bx3 | Shelf | 3 |
| Cx1 | Back Brace | 1 |
| Dx16 | Bolt (M6x16mm) | 16 |
| Ex16 | Washer | 16 |
| Fx16 | Nut | 16 |
| Gx1 | Allen Wrench | 1 |
| Hx1 | Tipping Restraint Kit | 1 |
Important Note: UNIT SHOULD BE ASSEMBLED BY TWO OR MORE PEOPLE. DO NOT TIGHTEN ANY BOLTS UNTIL ALL BOLTS HAVE BEEN STARTED!
Assembly Instructions
-
Step 1: Initial Frame Assembly
Refer to the diagram on page 2. Connect the side panels (A) to the base (B) using bolts (D), washers (E), and nuts (F) with the Allen wrench (G). Ensure all bolts are started but not fully tightened yet.
-
Step 2: Attach Shelves
Refer to the diagram on page 3. Attach the shelves (B) to the assembled side panels (A) using bolts (E), washers (D), and nuts (F) with the Allen wrench (G). Repeat for all three shelves.
-
Step 3: Attach Back Brace
Refer to the diagram on page 4. Attach the back cross brace (C) to the rear of the unit using bolts (D), washers (E), and nuts (F) with the Allen wrench (G).
-
Step 4: Install Tipping Restraint
Refer to the diagram on page 4. Install the tipping restraint kit (H) to secure the furniture unit. Follow the specific instructions provided with the kit for proper installation to prevent furniture tip-over.
⚠️ WARNING: The use of the included tipping restraint may reduce, but not eliminate, the risk of furniture tip over. Follow the instructions on the plastic bag for proper installation.
Contact & Support
For replacement parts or assistance, please contact Ashley Furniture Industries, LLC:
- Email: RTAParts@ashleyfurniture.com
- Website: www.ashleyfurniture.parts
- Phone: 1-844-966-0809
