MCombo Lift Recliner Owner's Manual

I. Safety Guidelines

1. Mandatory

Read the safety and other instructions thoroughly before using your MCombo® product. Failure to follow the guidelines, warnings in this manual and those located on your product can result in personal injury or product damage and will void the product warranty. Keep this manual for future reference.

2. Danger

• ⚠️ To prevent suffocation, keep plastic bags away from children.
• ⚠️ Do not allow children play on or near the chair when in use. Serious injury or death could occur if a child is under the chair when the chair is in motion.
• ⚠️ Keep cord out of reach of small children, and do not use where it may be a trip hazard.
• ? Plug directly into a wall outlet. Do not use an extension cord or adapter.
• ? Avoid exposing upholstered chair to burning cigarettes or cigars, open flames, and high temperatures.
• ? Do not use this product if it is wet, in water, around water or any liquid.
• ⬆️ Always leave in an upright and closed position. Keep hands and feet clear of mechanism and all moving parts. Footrest must be completely closed before getting in or out of the chair. Only the occupant should operate the chair.
• ? Before moving the product, disconnect the electrical plug from the wall outlet and secure the mechanism to prevent unexpected lifting and movement of the chair.

3. Warning

• Weight Capacity: 350 lbs.
• ? Do not use outdoors. INDOOR USE ONLY.
• ⚠️ To avoid tip over, do not put your weight against the back of the chair.
• ⚠️ Do not stand, sit, or place extra weight on the arms, back or open footrest.
• ❌ Do not use this product if it is damaged. Do not use attachments or substitute parts.
• ? Do not use this product if you have poor circulation, are mobility-impaired, or cannot sense heat, except as directed by your health care provider.
• ? Do not operate the unit until the back is installed and locked.
• ? Do not attempt to disassemble or repair the actuator or pump; no serviceable parts are inside.
• ⚠️ Do not allow electrical cord to be pinched between moving parts or between the frame and the floor. Do not place cord under carpet or in a location where it could become worn.
• ? Do not use pillow, blanket, or other cover between occupant and chair surface when heat is engaged.
• ? Do not attempt to disconnect the power plug by pulling the power cord. Always hold the power plug and pull it out.
• ?‍?‍?‍? Closely supervise children and disabled persons using this product.
• ⚠️ To reduce the risk of head entrapment and other injuries, keep children and pets away from openings and moving parts in and around furniture.
• ? Unplug power cords from outlet before relocating or troubleshooting.
• ⚠️ This product has many moving parts, serious injury can occur if not used properly. Keep hands, fingers, and body parts away from the mechanism.
• ?‍♂️ To exit the unit safely and prevent a tripping hazard, bring the back upright and close the footrest.
• ?️ Place tables and area rugs at a distance to allow the footrest to fully extend without rubbing or interference.
• ? Check the condition of the power supplies, electrical cords, plugs, and connectors often. Keep the power supplies and electrical cords away from heat sources. Never operate the unit with a damaged power supply, electrical cord, plug or connector.
• ? This product is not intended for use as a health care device. Some medications and physical limitations may impair your ability to operate this product in a safe manner. Consult your physician if you are taking prescribed or over the counter medication, or if you have physical limitations.
• ⏳ Do not charge your device into the USB charge ports over 24 hours.
• ⚡ Do not charge any devices over 5V/2A with the USB charge ports.
• ⚠️ Do not overlay the USB charge ports with other heat-dissipating electronic products. This may prevent heat dissipation and cause overheating or melting.
• ? Users of medical devices should contact their health care provider before using this product.
• ? Unplug the power cord immediately if you detect strange odors or fumes coming from the chair. Contact your MCombo Customer Support.
• ? Burns may result from improper use and care of internal heating parts. To avoid risk of burns, do not use pins, do not allow heating pad area to become wet, and do not remove upholstery cover.
• ? The chair is intended for a single occupant, not exceeding 350 lbs. Do not operate the chair with more than one occupant in or on any part of the chair.
• ? If you give this product to someone else, must include this owner's manual.

4. Symbols Information

The symbols below represent labels used on the product to identify warnings, mandatory actions, and prohibited actions. It is especially important for you to read and understand these symbols completely. Do not remove these labels from your product. Please note that not all the symbols may be used on your chair.

5. Disclaimer

Make sure you read and understand this manual completely before using your MCombo Product. We are not and cannot be held responsible for any damage or injury incurred due to improper or unsafe use of the MCombo Product. We specifically disclaim responsibility for any bodily injury or property damage that may occur during any use that does not comply with applicable federal, state, or local laws or ordinances.

II. Assembly Instructions

1. Product Parameters

2. Part List

Box 1 of 3

A Base x 1

Box 2 of 3

B Backrest x 1

D Lift Remote x 1 (6160-BB-LR1)

E Massage Remote x 1 (6160-BB-BM)

Box 3 of 3

C1 Right Armrest with USB x 1

C2 Left Armrest x 1

F Power Adapter x1 (6160-FF-29V)

G Anti-back-tipping x 2

H Rack circular gasket x 2 (Spare parts)

3. Assembly Steps

Step1 - Armrest Assembly

1. Ensure the armrest which has USB charge port is located on the right of the base.
2. Slide the left and right armrest into the brackets of the base.
3. Press each armrest down as far as it will go. (Diagram shows armrests clicking into place on the base.)

Step2 - Backrest Assembly

1. Align the brackets of the backrest at the clips of the seat-back. (Diagram shows alignment.)
2. Push the brackets into the seat-back tightly. Listen for a "click" sound on each side to ensure the backrest is locked in properly. (Diagram shows pushing down and an 'attention' box with an arrow indicating to remove a plastic cap before assembly.)

Step3 - Lift Connections

1. Connect the chairs according to the following wiring diagram. (Diagram shows electrical connections between the base, motor, and remotes.)
2. Attach the chair-back to the velcro on the bottom of the chair base.

Step4 - Anti-back-tipping Part Assembly

1. Place the Anti-back-tipping parts (G) near the bottom of the base.
2. Align the screws with the holes then tighten the wing screws. (Diagram shows attaching these parts to the base.)

Step5 - Final Check

1. Make sure both metal brackets on each armrest are mounted on the base. (Note: Ensure armrests are fully seated, not just in one bracket.)
2. Make sure the backrest inserts are locked to the base. (Pull up the backrest to check if it is locked in place.)
3. Make sure all wires are connected tightly.
4. Make sure all wires are not placed on the bottom of the rack and will not be pressed by the frame. (If a wire is pressed by the frame, it may break and the chair will stop working.)
5. Make sure the anti-tilt fitting screws are tightened.

III. Operating Instructions

1. Operation Precautions

• Do not use an extension cord.
• Do not exceed recommended weight limit.
• Do not use attachments not recommended by the manufacturer.
• ? Do not use outdoors. INDOOR USE ONLY.
• Stay away the backrest from wall at least 17.7 inches before using.
• Use this lift only for its intended use as described in the operating.
• Keep dry. Do not operate in a wet or moist environment.
• Keep all cords away from heated surfaces and pinch points.
• Ensure the hand control is out of the way before sitting in the chair.
• Always leave the lift chair in an upright and closed position when not in use.
• Periodically check the hand control and all power cords for visible damage.
• Do not use the footrest as a seat, or for purposes outside its intended use.
• Do not lean or apply downward force to the chair-back while in recline position.

2. Lift Remote Operation Instruction

⬆️ LIFT (UP)

Press and hold the UP button to raise the chair to the full-lift position.

Press and hold the UP button to return to the seated position from the reclined position.

⬇️ LIFT (DOWN)

Press and hold the DOWN button to lower the chair to the seated position.

Press and hold the DOWN button to raise the footrest and recline the chair back.

3. Massage Remote Operation Instruction

• HEAT: Turn on/off heat function
• POWER: Turn on/off remote control (Only control massage function)
• MODE: Press to select 3 different massage modes
• TIMER: The timer can be set in fixed time 10 / 20 / 30 minutes
• INTENSITY: Press to adjust massage intensity from low to high
• POINTS: Control massage points (BACK, LUMBAR, THIGH, LEG)

IV. Care and Maintenance

Your MCombo product will provide years of superior performance and satisfaction with regular care and maintenance. To maintain the finish quality of your "assistant", please follow the guidelines and cleaning procedures provided below.

1. Fabric Care

• Inspect the fabric on a regular basis for any pulls, tears, or gaps.
• Frequent vacuuming or light brushing with a nonmetallic, stiff bristle brush to remove dust and grime is recommended.
• When liquid spills onto the fabric, please immediately wipe off liquid spills with a dry or lightly dampened clean white cloth, sponge, or paper towel.

2. Faux Leather Care

• Wipe leather down regularly with a clean, dry microfiber cloth.
• For more stubborn dust, dampen the cloth with distilled water. Make sure that the cloth is not soaking wet. Never let water soak into leather.
• Always be sure to use a soft cloth and never use an abrasive brush or scrubber as this can scratch and damage the leather.

3. Electronics Care

• Inspect all wiring harnesses to make sure they are not damaged or stuck under chair.
• Keep all the electronics free from moisture and temperature extremes.
• Check electrical components frequently for signs of corrosion and replace as necessary.
• Contact MCombo Customer Support if damage is present, do not fix it by yourself.

4. Disposal & Recycling

Your power recliner sofa must be disposed of according to applicable local and national statutory disposal regulations. Contact your local waste disposal agency for information on proper disposal of recliner sofa packaging, metal/wood frame components, fabric, electronic components.

V. Troubleshooting

The following troubleshooting FAQs should summarize what you need to know about your power recliner sofa. If at any time you do not feel comfortable performing the troubleshooting steps listed in this manual, please contact MCombo Customer Support for service.

Lift Motor Replacement:

Step1 - Turn the Chair to the Left

First turn the chair to the left, the right armrest is upward, be careful not to break the wire of USB charge ports.

Step2 - Unplug the Wire of Lift Motor

The motor connection has a clip that needs to be released to unplug the wire.

Step3 - Remove Bolts

The process involves removing a paper clip and then a bolt securing the lift motor. This is done in stages:

1. Observe the original position of the paper clip.
2. Twist the paper clip to release it.
3. Pull out the paper clip.
4. Pull out the bolt.

Step4 - Replace the New Lift Motor

Insert bolts and paper clips at both ends of the lift motor. Ensure the motor is oriented correctly.

1. Insert the bolt.
2. Insert the paper clip.

Step5 - Plug in the Wire of Lift Motor

Step6 - Final Check

Check & Confirm

1. Make sure bolts and paper clips are fully inserted.
2. Make sure the lift motor is installed in the correct direction.
3. Make sure the wires are not crushed by the seat frame.

VI. Disassembly Instructions

Step1 - Disconnect all Connections

Please disconnect all connections on the chair base and backrest before disassembling.

Step2 - Disassemble Backrest

1. Pushing the metal ears of the backrest inserts outward (Refer to arrow direction).
2. After unlocking the metal lugs on both sides of the backrest, hold the bottom part of the backrest marked in the picture below and pull it vertically upward.

Step3 - Disassemble Armrests

1. Use your knees to find a support point on the seat and press on the base with your own strength.
2. Hold the two marked positions at the bottom of the armrest and lift the armrest vertically upward. (Refer to arrow direction and the circular marking area.)

VII. Warranty

CONSUMER WARRANTY LIMITATIONS AND EXCLUSIONS

All warranties begin on the date of delivery. All warranties are to the original purchaser from MCOMBO® ONLY.

• MCOMBO® will replace the defective parts or send replacement product provided that the warranty parts have not been subjected to misuse, abuse or improper service by the consumer, for example, damaged wire arising in consequence of negligence or improper operation.
• Exclusions also include components with damage caused by:
  • Contamination
  • Abuse, misuse, accident, or negligence
  • Commercial use, or use other than normal
  • Improper operation, maintenance, or storage

VIII. Return / Replacement Policy

Return/ Replacement Policy

MCOMBO®

You have 30 days from the date of purchase to return any item purchased from our store. Please securely pack the item in its original packaging, including any accessories or manuals that came with the product. To initiate a return, please contact our customer service team at sales@mcombo.com/ 323-597-1109 for any help.

Return Conditions

We accept the return of items that are in new, unused condition, with original tags attached and all original packaging and other components included. Refunds will be issued in the original form of payment for the price of the item, including taxes.

IX. MCOMBO Customer Support

If for any reason, we have fallen short of your expectations, or if you have any questions and suggests, please refer to the following contact information, we will do our best to work with you to make sure you are entirely satisfied.

• Email: sales@mcombo.com (Respond within 24 hours)
• Phone: 1-323-597-1109 (8:00 a.m. -- 4:00 p.m. Monday--Friday TIME ZONE: PST)

Locations:

• DE: 2411 Bear Corbitt Rd STE 1, New Castle, DE, 19720
• TN: 3980 PREMIER AVE, MEMPHIS, TN, 38118
• CA: 2808 Vail Ave, Commerce, CA, 90040