GODIAG GT115 For V-A-G MQB IMMO4 CAN-Bus UDS 4th Generation IMMO System Test Platform

Product Overview

The GODIAG GT115 is a connecting cable designed for the MQB IMMO system, catering to VAG models ranging from superminis to large family cars. This system replaces the PQ25, PQ35, and PQ46 platforms. The GT115 enables engineers to conveniently perform off-vehicle operations such as IMMO programming, matching, and diagnostics on the MQB IMMO system. It features a POGO PIN for reading and writing data to the dashboard, ensuring a stable connection without damaging the cable.

Functions:

1. Synchronous detection of key and vehicle IMMO module.
2. Independent diagnosis of engine and power expansion module.
3. Communication diagnosis and programming test of engine module and power module through gateway module.
4. IMMO 4th generation POGO PIN read and write data and key synchronization detection.
5. Connect BCM module with gateway module for communication diagnosis and programming test (Note: Press the corresponding switch when required).
6. Gateway module detection.
7. Current connected power supply voltage display.
8. Current connected module current display.
9. 2032 battery voltage detection.
10. With POGO PIN to read and write data to the dashboard.

Steps to Detect Keys Using the IMMO 4 CAN-BUS UDS Platform

Step 1: Connect the GT115 to the dashboard and connect it to the power supply.

Step 2: Press the start button, press the ignition button, and then press the Dash button.

Step 3: The instrument panel displays 'SAFE', and the key sensor coil flashes for 3 seconds and then goes out. This indicates that the key is not recognized.

Step 4: Connect the GT115 to the dashboard and connect it to the power supply.

Step 5: Press the start button, press the ignition button, and then press the Dash button.

Step 6: The instrument panel displays the mileage, and the key sensor coil flashes and then goes out. This indicates that the key has been identified.

Steps to Use POGO PIN on IMMO 4 CAN-BUS UDS Platform

Step 1: Connect GT115 to the instrument panel and power it on.

Step 2: First press the red ignition button, then press the “Dash” button.

Step 3: Use the pogo pin probe to poke the pogo pin point in the instrument chip.

Step 4: After poking, do not let go and press the start button again.

Step 5: Wait for 5 seconds and then release the pogo pin probe.

Step 6: At this time, only one light is on, indicating that the instrument has successfully entered the pogo pin mode.

Steps to Use on the MQB Platform

Step 1: Connect the gateway.

Step 2: Connect the BCM module.

Step 3: Connect the instrument.

Steps to Use Engine Independent Communication

Step 1: Connect the engine with colored jumper wires.

Step 2: Connect to power.

Step 3: Press in sequence: power switch start, ignition switch IGN, engine button switch ENG.

Step 4: Then connect other devices to the OBD port for testing and diagnosis.

Accessories:

• 1pc x GT115 MQB IMMO4 CAN-Bus UDS 4th Generation IMMO System Test Platform
• 1pc x PDF manual