Potentiometer Technical Drawings and Dimensions

Component Overview

This section details the physical dimensions and features of the potentiometer.

Side View

The side view illustrates the potentiometer's shaft and body. Key dimensions include:

• Shaft length (L) and diameter (D) are indicated.
• Body dimensions: 9.30 (width), 2.00 (depth from front), 6.50 (shaft protrusion from body).
• A threaded mounting boss is specified as M7*0.75.
• Overall depth from the mounting boss to the rear is 3.80 and 2.00.

Top View

The top view shows the main body diameter and adjustment mechanism. Key dimensions and features include:

• Body diameter: Ø16.90.
• Adjustment slot dimensions: 7.80 (width), 1.20 (depth).
• The adjustment mechanism is shown at a 30-degree angle relative to a reference line.
• The potentiometer has three terminals, labeled 1, 2, and 3.
• The diagram indicates the "shaft shown in full C.C.W. position" (Counter-Clockwise).
• The height (H) of the terminal section is indicated.
• A dimension of 4.00 is shown from the bottom of the terminals to the base.

Mounting Surface Details

This section illustrates the layout for mounting the potentiometer.

• Three mounting holes are depicted, labeled 1, 2, and 3.
• The diameter of each mounting hole is 1.20 (specified as 3-Ø1.20).
• The spacing between the centers of these holes is 5.00.
• A dimension labeled 'D' indicates the distance from the mounting surface to the component body.