Datalogic PowerScan PM9600 Series Regulatory Addendum

Company Information and Legal Notices

Datalogic S.r.l.
Via S. Vitalino, 13
40012 Calderara di Reno (BO) Italy
Tel. +39 051 3147011
Fax +39 051 3147205

©2022-2023 Datalogic S.p.A. and/or its affiliates. All rights reserved.

No part of this documentation may be reproduced, stored in a retrieval system, or transmitted in any form or by any means without the express written permission of Datalogic S.p.A. Electronic versions are available at www.datalogic.com.

Disclaimer: Datalogic has taken reasonable measures to provide complete and accurate information. However, Datalogic shall not be liable for technical or editorial errors or omissions, nor for incidental or consequential damages. Datalogic reserves the right to change specifications without prior notice.

Trademarks: Datalogic and the Datalogic logo are registered trademarks of Datalogic S.p.A. PowerScan is a trademark of Datalogic S.p.A. All other trademarks are property of their respective owners.

Patents: See www.patents.datalogic.com for patent list.

Model Numbers: PM9600, PM9600DPX, PM9600AR, BC9600-433, BC9600-910, BC9620 type 433/910/BT.

Important Caution: Do not insert objects like coins, paper clips, or stickers between the reader's boot and the base charger. Do not apply stickers on the sides of the reader's boot. Areas indicated by red arrows in the original image are affected.

This document is an addendum to the Quick Start Guide (QSG) for this product.

Regulatory Information

All models are designed to comply with rules and regulations in their sales locations and will be labeled as required. Modifications not expressly approved by Datalogic could void the user's authority to operate the equipment.

Statement of Agency Compliance (FCC)

This device complies with Part 15 of the FCC Rules. Operation is subject to two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by Datalogic could void the user's authority to operate the device.

FCC Class B Compliance Statement

This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. If interference occurs, users are encouraged to try correcting it by: reorienting the receiving antenna, increasing separation between equipment and receiver, connecting equipment to a different circuit, or consulting a dealer or technician.

FCC RF Exposure Information

This equipment complies with FCC radiation exposure limits for an uncontrolled environment. It should be installed and operated with a minimum distance of 5mm between the radiator and your body. This transmitter must not be co-located or operating with any other antenna or transmitter.

IC Canada Notice

This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada's licence-exempt RSS(s). Operation is subject to the following conditions: 1. The device may not cause interference. 2. The device must accept any interference, including interference that may cause undesired operation. 3. A separation distance of at least 20 cm must be maintained between the antenna and all persons to comply with safety requirements for mobile RF exposure conditions in accordance with RSS-102 Issue 5.

(French translation provided in original document, omitted here for brevity in primary language focus).

Reader PowerScan PM9600 Canada Notice (RF Exposure Safety)

According to "RSS-102 Issue 5 (2015-03)", the device operates below applicable output power levels for the specified separation distance. Evaluation was done at 5mm.

(French translation provided in original document, omitted here for brevity in primary language focus).

Base Charger BC9600-433/910 and BC9620 type 433/910/BT FCC

CAUTION: Exposure to Radio Frequency Radiation
To comply with FCC RF exposure compliance requirements, for mobile configurations, a separation distance of at least 20 cm must be maintained between the antenna of this device and all persons.

EAC (Customs Union)

The CU conformity certification has been achieved, allowing the product to bear the Eurasian mark of conformity.

Frequency Information

Frequency Band Used: 433.050-434.790 MHz; 902-928 MHz; 2400-2483.5 MHz

Maximum output power: < 10 dBm for 433MHz and 910MHz; < 20 dBm for Bluetooth.

Power Supply Requirements

This device is intended for connection to a UL Listed/CSA Certified computer supplying power directly, or to a UL Listed/CSA Certified Power Unit marked "Class 2" or LPS power source rated 10-30V minimum 1.5A.

Argentina Power Supply Statement

Atención: Características de la fuente de alimentación eléctrica. Entrada: 100-240 Vca, min 400mA 50-60 Hz. Salida: 12VDC, máx 1500mA, (-) Negativo al centro. Use only certified power sources in Argentina. Incompatible power sources may pose a fire or electric shock risk.

Mexican Declaration

La operación de este equipo está sujeta a las siguientes dos condiciones: "(1) es posible que este equipo o dispositivo no cause interferencia perjudicial y (2) este equipo o dispositivo debe aceptar cualquier interferencia, incluyendo la que pueda causar su operación no deseada."

ANATEL - Brasil

Este equipamento não tem direito à proteção contra interferência prejudicial e não pode causar interferência em sistemas devidamente autorizados.

Device Labeling

Sample labels are shown to illustrate their location. Actual labels on the product may vary.

Scanner Regulatory Label: Includes Aiming System and Output Window information.

Base Regulatory Label: For 433/910 MHz and BT devices.

Laser Safety Regulations

The aiming system of this device meets Class 2 laser safety requirements. Laser information is on the scanner label. The laser scanner conforms to CDRH 21 CFR 1040 and EN60825-1 at the date of manufacture. The laser light is visible and emitted from the output window.

Standard Laser Safety Regulations:

This product conforms to CDRH 21 CFR 1040 and EN 60825-1 at the date of manufacture. Opening the device for installation, use, or maintenance is not necessary.

⚠️ WARNING: Use of controls, adjustments, or procedures other than those specified herein may result in exposure to hazardous visible laser light.

The product uses a low-power laser diode. While momentary exposure to the beam is not known to cause biological damage, avoid staring at the beam like any strong light source (e.g., the sun). Avoid directing the laser beam into an observer's eye, even through reflective surfaces.

CAUTION: The PowerScan™ Handheld Reader is not user-serviceable. Opening the case can cause internal damage and will void the warranty.

(Multilingual laser safety text blocks from original document are consolidated into English here for clarity and conciseness.)

WEEE Statement

For information about the disposal of Waste Electrical and Electronic Equipment (WEEE), please refer to the Datalogic website at www.datalogic.com.

(Multilingual WEEE statements are consolidated into English.)

China RoHS

The following tables indicate the presence of restricted substances in the scanner and base components, according to China RoHS standards.

CHINA ROHS TABLE OF RESTRICTED ELEMENTS (SCANNER)

Note: 'X' indicates the substance exceeds the limit; 'O' indicates it is below the limit. EFUP (Environmentally Friendly Use Period) is determined by the "Look-up Method".

CHINA ROHS TABLE OF RESTRICTED ELEMENTS (BASE)

Note: 'X' indicates the substance exceeds the limit; 'O' indicates it is below the limit. EFUP (Environmentally Friendly Use Period) is determined by the "Look-up Method".

Wireless Charging System

WPT frequency: 120kHz-150kHz

Max Power @3m: 18.3 dBuA/m

Declarations of Conformity

European Declaration of Compliance

Datalogic S.r.l. declares that this radio equipment is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at: www.datalogic.com (Select Support & Service > Downloads > Product Certifications).

(Multilingual declarations are listed in the original document; key information is presented in English.)

UKCA Declaration of Conformity

Datalogic S.r.l. declares that the full text of the UKCA Declaration of Conformity is available at: www.datalogic.com (Select Support & Service > Downloads > Product Certifications).