Datalogic PowerScan PBT9501 Regulatory Addendum

Regulatory Information

All models are designed to be compliant with rules and regulations in locations they are sold and will be labeled as required. Any changes or modifications to equipment, not expressly approved by Datalogic could void the user's authority to operate the equipment.

Statement of Agency Compliance

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

FCC RF Radiation Exposure Statement

⚠️ CAUTION: Exposure to Radio-Frequency Radiation

To comply with FCC RF exposure compliance requirements, for mobile configurations, a separation distance of at least 20 cm must be maintained between the antenna of this device and all persons. This device must not be co-located or operating in conjunction with any other antenna or transmitter.

NCC Statement (Taiwan)

According to NCC low-power radio frequency electrical equipment management regulations:

• Article 12: Low-power radio frequency electrical equipment that has passed type certification, without permission, companies, businesses, or users shall not arbitrarily change frequency, increase power, or change the original design characteristics and functions.
• Article 14: The use of low-power radio frequency electrical equipment shall not affect flight safety and interfere with legal communications; if interference is found, it shall be stopped immediately and improved until there is no interference before continuing to use. The legal communications mentioned in the preceding paragraph refer to radio communications operated in accordance with the Telecommunications Act. Low-power radio frequency electrical equipment must tolerate interference from legal communications or industrial, scientific, and medical radio frequency electrical equipment.

Module Labeling: After obtaining certification, the module will be labeled with the approval label as required, and the platform manufacturer will be required to label 'This product contains transmitter module: CCAJ14LP0060T3' on the platform.

Cofetel Mexico Update

This product is usable in Mexico. Certificate No. RCPDADL09-1251 (COFETEL).

The operation of this equipment is subject to the following two conditions: (1) this equipment or device may not cause harmful interference, and (2) this equipment or device must accept any interference, including that which may cause its undesired operation.

Customs Union

The CU conformity certification has been achieved; this allows the Product to bear the Eurasian mark of conformity. [Eurasian Conformity Mark]

Frequency Band Used

2400-2483.5 MHz

Maximum Output Power

< 20 dBm

Imager and Laser Safety Information

Imager Labeling

The PowerScan™ aiming system meets the Class 2 requirements for laser safety. The laser information is located on the sides of the Scanner as shown below. Sample labels are shown here to illustrate their location only. Please view the labels on your product for actual details, as they may vary from those depicted.

Diagram description: Shows regulatory labels on the scanner, indicating the aiming system output window.

Laser Safety

⚠️ CAUTION: The PowerScan™ Handheld Reader is not user-serviceable. Opening the case of the unit can cause internal damage and will void the warranty.

Standard Laser Safety Regulations: This product conforms to the applicable requirements of both CDRH 21 CFR 1040 and EN 60825-1 at the date of manufacture. For installation, use, and maintenance, it is not necessary to open the device.

Laser Light Warning: Using procedures or adjustments different from those described in the documentation may result in dangerous exposure to visible laser light.

The product uses a low-power laser diode. Although no human eye damage has been reported from short-term exposure, avoid staring at the laser beam, just as you would avoid any other intense light source, such as the sun. Also, avoid directing the laser beam into the eyes of an observer, even through reflective surfaces like mirrors.

WEEE Statement

For information about the disposal of Waste Electrical and Electronic Equipment (WEEE), please refer to the website at www.datalogic.com.

China RoHS Table of Restricted Elements

Scanner Component Restrictions

This table is prepared according to SJ/T 11364. 'X' indicates that the content of the hazardous substance in at least one homogeneous material of the part exceeds the limit requirement specified in GB/T 26572. 'O' indicates that the content of the hazardous substance in all homogeneous materials of the part is below the limit requirement specified in GB/T 26572. EFUP determined by "Look-up Method" (scanner).

Base Component Restrictions

This table is prepared according to SJ/T 11364. 'X' indicates that the content of the hazardous substance in at least one homogeneous material of the part exceeds the limit requirement specified in GB/T 26572. 'O' indicates that the content of the hazardous substance in all homogeneous materials of the part is below the limit requirement specified in GB/T 26572. EFUP determined by "Look-up Method" (scanner).

EU Declaration of Conformity

Apparatus / Apparato / Aparato / Appareil / Gerätetyp / Apparaatmodel / Apparatmodell: PowerScan PBT9501; Cordless Barcode Reader, BC9XY0-BT; Cordless Base Station/Charger and all its models.

Manufacturer: Datalogic S.r.l., Via S. Vitalino 13, 40012 Lippo di Calderara (BO) - Italy

The object of the declaration described above is in conformity with the relevant Union harmonization legislation:

• 2014/53/EU RED Directive
• 2011/65/EU RoHS Directive

References to the relevant harmonised standards:

• ETSI EN 301 489-1 V2.2.0 MARCH 2017
• ETSI EN 301 489-17 V3.2.0, MARCH 2017
• ETSI EN 300 328 V2.1.1, NOVEMBER 2016
• EN 62311:2008
• EN 60950-1, DECEMBER 2006 + AMENDMENT A11:2009 + AMENDMENT A1:2010 + AMENDMENT A12:2011 + AMENDMENT A2:2013
• EN 50581, SEPTEMBER 2012

Declaration Date: August 29th, 2019

Signed by: Ruggero Cacioppo, Product Quality Leader

Patents

This product is covered by one or more of the following patents. For a complete list, please visit www.patents.datalogic.com.

Design Patents: AU344427, AU344428, AU344429, EP001970237, EP002109371, TWD159476, TWD159477, TWD160254, TWD160255, USD682277, USD702238, USD716818, ZL201230284676.X, ZL201330082835.2

Utility Patents: EP1114390B1, EP1128315B1, EP1172756B1, EP1396811B1, EP1413971B1, EP1816585B1, EP1825417B1, EP1828957B1, EP1873886B1, EP2275966B1, EP2382502B1, EP2517148B1, EP2521068B1, EP2649555B1, JP4435343B2, US6478224, US6512218, US6513714, US6561427, US6808114, US6877664, US6997385, US7053954, US7234641, US7387246, US7721966, US7948214, US8245926, US8561906, US8743263, US8888003, US8915443, US9430689, US9482793, US9798948, ZL200780030808.2, ZL200880132595.9, ZL200980163411.X, ZL201080071124.9