FlexAlert Quickstart Guide

from Trumeter

Starting and Resetting the Unit

Unclip housing by twisting a flat screwdriver in the slot between front and rear cover. [Illustration: Screwdriver being used to separate the device halves.]
To turn on, remove battery insulation tab ensuring the battery remains in place. [Illustration: Battery with a pull-tab being removed.]
To reset, remove old battery. Insert CR2032 battery into the battery holder. The markings on the battery holder specify the orientation of the battery. [Illustration: Old battery removed, new CR2032 battery inserted with correct orientation.]

Turning on the Unit

The buzzer will beep 4 times to confirm the battery is fitted correctly and the timer has now started.
Clip the rear cover back on to the front cover taking care to align the cut outs of front and rear housing. [Illustration: Rear cover being attached to the front cover.]

Note: Unit begins to count to the pre-programmed time duration (1-732 days). Once pre-programmed time has elapsed, the unit will make a repeated audible sound, beeping every 2 seconds until the battery is replaced.

Mounting using Hook and Loop

Peel film from one side and stick to rear cover of unit. [Illustration: Adhesive backing being removed from one side of a hook and loop pad and applied to the back of the FlexAlert device.]
Peel film from opposite side and stick hook and loop pad to desired area. [Illustration: The other side of the hook and loop pad being applied to a mounting surface.]

Mounting using Cable Tie

Slide cable tie through the slots on the rear cover. [Illustration: Cable ties being threaded through the mounting slots on the back of the FlexAlert device.]
Tighten cable around pipe or filter. [Illustration: The FlexAlert device secured to a pipe with a tightened cable tie.]

Contact Us

Europe - Trumeter

Pilot Mill, Alfred Street, Bury, BL9 9EF UK

Tel: +44 161 674 0960 Email: sales.uk@trumeter.com

Americas - Trumeter

6601 Lyons Rd, Suite H-7, Coconut Creek, Florida, 33073 USA

Tel: +1 954 725 6699 Email: sales.usa@trumeter.com

Asia Pacific - Innovative Design Technologies

Lot 5881, Lorong Iks Bukit Minyak 1 Taman Perindustrian Iks, 14000 Bukit Tengah, Penang, Malaysia

Tel: +604 5015700 Email: info@idtworld.com

Information

WARNING

CAUTION: CHOKING HAZARD - small parts. Not suitable for children under 3 yrs.

⚠ CE

	Trumeter APM Gateway Quickstart Guide A quickstart guide for the Trumeter APM Gateway, covering device wiring, powering, cloud access, and new user account creation. Includes technical specifications and safety warnings.
	Trumeter Vista Touch Modbus Communications Guide Comprehensive guide to Modbus RTU and TCP/IP communications for the Trumeter Vista Touch series, detailing data types, protocols, function codes, configuration, and address maps.
	Trumeter 7110DIN 8 Digit Totalising Counter: Specifications and Guide Comprehensive technical specifications, connection diagrams, and mounting instructions for the Trumeter 7110DIN 8-digit totalising counter, suitable for various industrial and counting applications.
	Trumeter Model 3602/3603/3604 Reset Instructions Instructions for resetting Trumeter Model 3602, 3603, and 3604 counters, emphasizing correct procedures and warnings against improper methods.
	Trumeter ADM Series Graphical Panel Meters - Versatile Programmable Features Explore the Trumeter ADM Series Graphical Panel Meters, offering versatile programmable features, user-configurable alarms, and flexible metering solutions for voltage, current, and frequency measurement. Learn about specifications, dimensions, and wiring.