Gyroor H30 Pro Electric Scooter

Product Overview & Safety Warning

Warm Tips: If you don't use the scooter for a long time, please charge it once a month.

Caution: Please read the operating instructions before riding. Beginners need to be accompanied by parents or adults to practice cycling in open spaces. The operator can ride independently only after mastering the kinetic energy and riding skills of the scooter.

1. Product Accessories

The Gyroor H30 Pro Electric Scooter includes the following components:

• Charging port
• Silicone ring
• Bluetooth board
• Front fork
• Front wheel
• Vertical pipe Fix screw Lock Cap
• Mat
• Trumpet
• Light bar (front and rear)
• Lampshade (front and rear)
• Rear mudguard
• Brake plate
• Foot sandpaper
• Bottom shell
• Pedal leather
• Briquetting (x2)
• Mainboard
• Charging switch
• Frame
• Battery
• Rear wheel
• Bottom plate

2. Product Installation

Follow these steps to assemble the scooter:

1. Attach the horizontal rod to the handlebar fixed block.
2. Use a screw to tighten the handlebar fixed block towards the indicated arrow.
3. Attach the vertical rod to the bottom plate and align it with the screw hole.
4. Use a screw to tighten the cap in the direction of the arrow.

3. Product Expansion and Height Adjustment

Adjust the scooter's height for optimal use:

1. Unscrew the height adjustment mechanism in the direction of the arrow.
2. Press the vertical lever to release the locking mechanism, then grab the handle and pull it up or down to adjust the height.
3. Tighten the mechanism securely after adjusting to the desired height.

4. Introduction to Riding Operations

Starting Method:

Hold the handle with both hands and gently push forward. A single "drop" sound from the buzzer indicates a speed of 4 KM/H. Three "drops" indicate a speed of 8 KM/H.

Gear Change Mode:

After starting the motor, press the pedal switch 5 times continuously to cycle through different speed gears.

Speed Setting Confirmation:

A successful speed setting is confirmed by buzzer sounds: 1 sound for 4 KM/H, 2 sounds for 6 KM/H, and 3 sounds for 8 KM/H.

Automatic Turn Off:

The scooter will automatically turn off after 15 seconds of inactivity. To resume, slide the motor again.

Bluetooth Music:

Connect your electric scooter to your mobile phone via Bluetooth. The Bluetooth name will appear as "Wheel Music". You can then play music while riding.

Lights:

After the motor starts, the lights cycle from cyan to seven colors, then turn off. They will turn on again when the induction contact is pressed. If the scooter is not started, pressing and releasing the foot switch will not produce a buzzer sound.

Riding Method:

Hold the handle with both hands. Place one foot on the foot switch and use the other foot to push off and accelerate. Once the gliding speed reaches approximately 3 KM/H, the scooter will begin to increase speed according to the selected gear. Maintain a uniform speed.

Stop Method:

1. Use one foot to step on the rear wheel brake plate.
2. Remove your foot from the foot switch on the pedal to complete the stop.

Low Battery Indication:

If the scooter emits a continuous sound of "drops, drops, drops", the battery is low. Please charge the scooter promptly.

5. Safety Instructions

1. This product is a mini electric power-assisted scooter for children and is restricted to one child. It should not be used by adults or two people simultaneously. Children must be accompanied by parents or adults when using electric-assisted scooters.
2. When riding, wear a safety helmet and other protective equipment.
3. Do not ride in unsafe or illegal locations, such as motor vehicle lanes.
4. Practice in an open space and master the operation before riding.
5. Avoid dangerous maneuvers or riding one-handed while the scooter is in motion. Keep feet on the pedal.
6. Do not attempt to cross steps or gaps larger than 3 cm, as this may cause the scooter to overturn, leading to rider injury or damage to the scooter. Steps below 3 cm should be avoided as much as possible.
7. On rough or uneven road conditions, slow down or dismount.
8. Adjust the product's height to a proper position to ensure safe driving.
9. Do not ride on slippery surfaces like oil or ice.
10. Do not use the product in temperatures below -5°C.
11. Do not use on slopes exceeding 15 degrees. For uphill riding over 15 degrees, pedal assist is required.
12. Do not immerse the product in water depths exceeding 5 cm to prevent damage to electrical components from water ingress.
13. In adverse weather conditions such as rain, snow, or wind, avoid riding to prevent unnecessary damage.
14. If the product is fully charged and not used for over a month, charge it at least once a month. If the battery is exhausted during use, charge it every 7 days.

6. Battery and Charger

Lithium Battery Care:

• Fully charge the battery before the first use.
• Charge promptly after the low battery warning tone to prevent battery damage.
• If the battery is not used for an extended period, charge it at least once a month (while fully charged).
• If the battery level drops below the protection status due to prolonged disuse, it may become unusable. Contact the dealer for assistance.

Note: Battery damage due to water, collision, or other abnormal factors is not covered by the warranty.

Charger Usage:

• The dedicated charger has a charging protection function and stops charging automatically at 100%.
• Open the charging rubber cover on the pedal and insert the charger output connector into the charging hole.
• Plug the charger input power into a power socket (AC100V-240V).
• The charger indicator light is red while charging and turns green when the battery is fully charged.
• Charge the battery in a dry and ventilated environment.

7. Scope of Warranty

Under normal use, Gyroor provides after-sales service for the following parts during the warranty period. Please contact Gyroor or a product distributor.

Note: The above quality issues are covered by free service without maintenance fees. Please use products correctly. Damage caused by abnormal use is not covered by free maintenance.

Warranty Exclusions:

Damage caused by the following reasons is not within the scope of quality assurance:

1. Using the electric scooter for dangerous actions like stunts, resulting in damage or malfunction.
2. Any disassembly or use of parts outside the original factory specifications.
3. Damage to the body or parts due to mistakes, traffic accidents, or accidental collisions.
4. Incomplete labels, water damage, or part number mismatches.
5. Damage or malfunction caused by riding on abnormal roads.
6. Commercial rental or improper use.
7. Unforeseeable natural disasters.
8. Exposing the product to prolonged sunlight or rain, causing rapid aging and failure.

8. Package Attachment

Note: Actual shipment product performance and parameters are subject to change without notice.

9. Parameters

10. Contact Information

Contact Gyroor if you experience issues relating to riding, maintenance, safety, or errors/faults with your scooter.

Messenger: Gyroor (scan the QR code on the back cover for more information)

Email: Service@gyroor.com, Support@gyroorboard.com

Website: www.gyroor.com

Please have your order number ready when contacting Gyroor.