Stilo WL-KEY Quick Instructions

Commands:

• 1. Power button: PTT function (road mode)
• 2. Volume down button
• 3. Volume up button

Turn ON

Press the central button for about 2 seconds until the two LEDs turn on to power the device.

Volume Regulation

Shortly press the '+' or '-' button to increase or decrease the volume by one step. The volume will adjust with each press.

Turn OFF

Press and hold the central button and the '-' button for about 2 seconds to turn off the device. The device will automatically turn off after 10 minutes if no connection to the control unit is detected.

Pairing

Perform the pairing operation for one helmet at a time.

• Turn the device off.
• Press the central button for 8 seconds; the blue and red LEDs will flash rapidly.
• Wait for pairing with the other device.
• On the main unit (DG), press and hold the corresponding 'helmet' button for 8 seconds.

Main unit connection

If disconnected, press any key to reconnect to the control unit once back within its 10-meter range.

Volume Regulation (Connected)

With the device connected, shortly press the '+' or '-' button to increase or decrease the volume by one step. The volume will synchronize with the main unit.

EVOLVED FUNCTIONS

Function MUTE

Press and hold the '-' button for 2 seconds to disable the helmet's microphone and audio. Pressing any key will restore communication. Communication can also be reactivated by pressing a volume key on the control unit. Mute function is not available during phone calls.

Side tone regulation

Press and hold the '+' button for 6 seconds to activate this function. Adjust your return voice volume using the '+' and '-' volume keys. The setting is automatically saved after 6 seconds of inactivity.

ROAD MODE ONLY

PTT (radio connection only)

Press and hold the center button to activate Push To Talk. A tone confirms the press, and radio transmission will be active after approximately 1 second and remain active until released. The red confirmation LED on the control unit will light up.

Incoming call

Press the '+' or '-' button to accept an incoming call.

Reject or end a call

To reject an incoming call, press and hold the '+' or '-' button for 2 seconds. To end an ongoing call, press and hold the '+' or '-' button for 2 seconds.

Callback last number

Press and hold the '+' and '-' buttons simultaneously for 2 seconds to call back the last number.

Battery specs

• Charge duration in continuous use: 4 hours
• Charging time (from low battery): 1.30 hours

Always recharge before use to ensure optimal battery life.