Outsunny 860-331V00 Outdoor Furniture Set
Model: IN231100519V01_GL / 860-331V00
Maximum Weight Capacity: ?️ 120kg
Estimated Assembly Time: ⏱️ 120 minutes
Introduction and Safety Information
Thank you for purchasing this Outsunny product. To ensure your furniture serves you well, please read all instructions in this user's manual carefully. If you have any questions, please contact our customer care center.
IMPORTANT: RETAIN FOR FUTURE REFERENCE: READ CAREFULLY.
This product is intended for domestic use only.
Usage Tips:
- Place the furniture stably on a flat floor.
- Install chairs under a shelter or awning.
- Keep away from open flames.
- Do not hang any materials on the structure.
- Avoid overloading the anchors/structure.
- It is advised not to stay on the furniture during a storm.
- Do not use in adverse weather conditions and cover furniture when not in use.
Precautions Before Assembly:
- Prepare a clean and dry mounting area.
- Verify that the product is not damaged.
- Check that none of the pieces are missing.
Maintenance:
- Clean with a soft fabric.
- Regularly remove leaves and/or water collected on the fabric.
- Check the furniture regularly for stability.
Storage Conditions:
- To avoid the risks of mold, the fabric should be stored completely dry in a clean and dry place.
General Maintenance Warning:
- Do not use this product if the seat cloths, cloth cushions, or tarpaulins are ageing. Contact our customer service immediately.
Caution: Be aware of the risks of pinching or cuts during assembly.
The manufacturer declines all responsibility in case of damages due to a bad installation or due to weather conditions.
Parts List
- Part A: Chair/Loveseat Side Frame (x3)
- Part B: Chair/Loveseat Side Frame (x3)
- Part C: Chair Lower Crossbar (x2)
- Part D: Chair Seat Frame (x2)
- Part E: Loveseat Seat Frame (x1)
- Part F: Loveseat Back Frame (x1)
- Part G: Table Base Frame (x1)
- Part H: Table Leg Support (x1)
- Part I: Table Top Frame (x4)
- Part J: Glass Tabletop (x1)
- Part O: Seat Cushion (x2)
- Part P: Back Cushion (x1)
Hardware List
- Screw K (M6*15): x8 (+1 spare)
- Screw L (M6*30): x29 (+1 spare)
- Washer M: x37 (+1 spare)
- Allen Key N: x1 ?
Note: Do not confuse similar screws. Do not tighten bolts fully until all parts are connected.
Assembly Instructions
Step 01: Assemble Chair Frames (x2)
For each of the two chairs, connect one part D (Chair Seat Frame) between two side frames (one part A and one part B) using four screws L (M6*30) and four washers M per chair. Ensure the frames are aligned before tightening.
Step 02: Attach Chair Lower Crossbars (x2)
For each chair, attach one part C (Chair Lower Crossbar) between the side frames (A and B) using four screws L (M6*30) and four washers M. This adds stability to the chair base.
Step 03: Assemble Loveseat Main Frame
Assemble the main frame for the loveseat. Connect one part F (Loveseat Back Frame) between two side frames (one part A and one part B) using four screws L (M6*30) and four washers M.
Step 04: Attach Loveseat Seat Frame
Attach the seat support for the loveseat. Connect part E (Loveseat Seat Frame) to the loveseat side frames (A and B) using five screws L (M6*30) and five washers M.
Step 05: Assemble Table Base Frame
Assemble the table base. Connect four parts I (Table Top Frames) to the main table frame G using eight screws K (M6*15) and eight washers M.
Step 06: Attach Table Legs
Attach the table legs. Connect part H (Table Leg Support) to the table frame G using four screws L (M6*30) and four washers M.
Step 07: Final Assembly
Place the glass tabletop J onto the assembled table base. Finally, place the two seat cushions O and the back cushion P onto the chairs and loveseat respectively to complete the set.
Importer and Distributor Information
US Importer: Aosom LLC, 27150 SW Kinsman Rd Wilsonville, OR 97070 USA. Made in China.
CA Importer: Aosom Canada Inc., 7270 Woodbine Avenue, Unit 307, Markham, Ontario Canada L3R 4B9. Made in China.
UK Importer: MH STAR UK LTD, Unit 27, Perivale Park, Horsenden lane South, Perivale, UB6 7RH. Made in China.
DE Importateur: MH Handel GmbH, Wendenstraße 309, D-20537 Hamburg, Germany. Made in China.
FR Importé Par: MH France, 2, rue Maurice Hartmann, 92130 Issy-les-Moulineaux, France. Fabriqué en Chine. For recycling information, please visit: https://quefairedemesdechets.fr ♻️
IT Importato: AOSOM Italy srl, Centro Direzionale Milanofiori, Strada 1 Palazzo F1, 20057 Assago (MI). P.I.: 08567220960. Fatto in Cina.
ES/PT Importador: SPANISH AOSOM, S.L., C/ ROC GROS, N° 15. 08550, ELS HOSTALETS DE BALENYÀ, SPAIN. Tel: 931294512. Made in China. (PT contact: INFO@AOSOM.PT, WWW.AOSOM.PT)








