M-Core R-Li Quick Start Guide
This is not a substitution for reading your Owner's Manual. For more in-depth instructions, please refer to your Owner's Manual.
Troubleshooting
Problem & possible solutions
- Sound is weak: Increase the volume, Recharge the hearing aid, Clean or exchange the click dome or wax protector
- Hearing aid emits whistling sounds: Reinsert the receiver until it fits securely, Decrease the volume, Clean or exchange the click dome or wax protector
- Sound is distorted: Decrease the volume, Recharge the hearing aid, Clean or exchange the click dome or wax protector
- Hearing instrument emits spontaneous signal tones: Recharge the hearing aid
- Hearing aid does not work: Turn the hearing aid on, Recharge the hearing aid, Power-on-delay is active. Wait several seconds and check again, Clean or exchange the click dome or wax protector
Consult your Hearing Care Professional if you have further problems.
Getting Started
1. Check the charging status of your hearing aid
| LED Status description | Charging Status |
|---|---|
| Orange LED | 0 to 33 % |
| Single green LED | 34 to 66 % |
| Two green LEDs | 67 to 99 % |
| Three green LEDs | Fully charged |
2. Turn your hearing aids on
- Your hearing aids turn on automatically when removed from the charger.
- They are programmed to have a start-up delay to allow you to insert without whistling.
- You will hear a melody during the start-up.
Choose start-up delay:
3. Insert your hearing aids
- Grasp receiver/dome between your thumb and forefinger.
- Insert dome into your ear canal.
- Gently work dome into proper position by slightly adjusting it until it is firmly seated in your ear.
- Lift the hearing aid over the top of your ear.
- Adjust it to fit behind your ear.
- Press slightly for a secure and comfortable fit.
- Place retention strand into the bottom "bowl" of your ear (if applicable).
Diagram: Illustration showing how to insert the hearing aid into the ear.
4. Using your hearing aids
- Your hearing aids feature Wireless Sync, which automatically adjusts both hearing aids simultaneously to reflect changes in your hearing environment.
- The rocker switch control on your hearing aids may be programmed to give you personal control of your hearing aids.
- The functions for short and medium press will change both hearing aids simultaneously.
Your controls
| Short (1 second) | Medium (2 seconds) | Hold* | ||||
|---|---|---|---|---|---|---|
| L | R | L | R | L | R | |
| Volume Up/Down | - | - | ||||
| Program Up/Down | - | - | ||||
| TV Stream | ||||||
| Power On/Off | ||||||
*Press and hold until hearing aid turns on/off
Your hearing aids may be programmed to alert you when you are making changes to your hearing aids or when your battery needs replacing.
Signal tones
| L | R | |
|---|---|---|
| Program Change | ||
| Volume Change | ||
| Volume Limit | ||
| Volume On Position | ||
| Low Battery | ||
| Bluetooth On/Off | ||
| Power On/Off |
Hearing aids you can rely on. Since 1955. | Rexton
