Regency Stainless Steel Wire Shelving Kit Assembly Instructions
Product Overview
This document provides assembly instructions for the Regency Stainless Steel Wire Shelving Kit.
Parts Included
- A: Shelves
- B: Posts
- C: Split Sleeves
- D: Casters (if included)
Diagram A Description: Shows the components of the shelving kit: a wire shelf, four posts, split sleeves for shelf placement, and optional casters.
Diagram B Description: Close-up of a single metal post with notches indicating 1-inch increments for shelf placement.
Diagram C Description: Close-up of split sleeves, which are plastic collars that attach to the posts to support the shelves. They are in two halves that snap together around the post and have an arrow indicating the correct orientation.
Diagram D Description: Close-up of a heavy-duty caster with a threaded stem for attachment to the posts.
Tools Suggested
- Rubber Mallet
- Cut-Resistant Gloves
Assembly Instructions
WARNING: Stainless steel edges may be sharp and cause cuts. Wear gloves and handle with care during installation and use.
NOTE: Every eighth groove is doubled for easy assembly. Posts are notched in 1-inch increments.
- Please inspect that all items are present and none are damaged before assembling.
- If assembling a mobile unit, insert the casters into the posts by simply pushing them in. If not, attach the foot levelers to the posts by twisting them in a clockwise direction.
NOTE: Pushing in the casters may take a bit of force, but the ring on the stem will hold them in place inside the post.
Image 2 Description: Illustration showing a hand pushing a caster stem into the bottom of a post. The stem has a ring that secures it inside the post.
- Snap (4) split sleeves onto each post for the bottom shelf. Ensure that the split sleeves have the arrow facing up.
NOTE: NSF requires that bottom shelves be at least 6 inches off the ground.
Image 3 Description: Illustration showing split sleeves being attached to a post at a specific notch. The sleeves are in two halves that snap together around the post.
- Hold the bottom shelf on its side and slide each post through the collars in the shelf until the sleeves fit firmly inside the shelf collars.
Image 4 Description: Illustration showing a wire shelf being lowered onto four posts, with the split sleeves already in place on the posts to support the shelf.
- Stand the unit upright and ensure that the shelf is secured. Use a mallet and towel to secure the shelf well without damaging it.
- Add additional split sleeves at desired shelf height and continue to place the remaining shelves on top of the posts, sliding them through the shelf slots until the sleeves fit firmly.
Image 5 & 6 Description: Illustration showing multiple shelves being added to the assembled posts, with a person using a rubber mallet to tap the shelf down onto the split sleeves for a secure fit.
- Screw the foot levelers in or out to level the entire unit.
Image 7 Description: Close-up of the bottom of a post with a foot leveler screwed in. The leveler can be adjusted by twisting to stabilize the unit on uneven floors.
Care and Maintenance
- Please check the weight capacity of the shelf AND unit and stay within the weight recommendations by evenly distributing items on the shelf.
- Dust the shelf or wipe down with a damp cloth or paper towel to clean off any dirt or food.
- For more information, please reference the Stainless Steel Care and Maintenance Guide.
Important Information
Manufacturer is not responsible for damage and/or injury caused by improper assembly, misuse, extended use past the life span, or unbalanced loading of the product. It is the user's responsibility to understand the product's use in each application.
