Two Installation Methods

STEP 1: Drill holes, then knock expansion bolt inside.

STEP 2: Tighten the nut, then install the door stop base.

STEP 3: Install 3 screws to fix the base.

STEP 4: Installation is complete, test back and forth.

STEP 1: Unscrew the base screws.

STEP 2: Install stainless steel gasket.

STEP 3: Tear off glue on one side.

STEP 4: Put the adhesive on the gasket.

STEP 5: Put the adhesive on the 2nd base.

STEP 6: The installation is complete.

STEP 1: Install expansion rubber plugs and screws to fix the base accessories.

STEP 2: Install the door stop base.

STEP 3: Install 3 screws to fix the base.

STEP 4: Installation is complete, test back and forth.