SwitchBot Floor Lamp Installation Guide
Parts List
- Lamp Base × 1
- Horizontal Stand × 2
- Vertical Stand × 1
- Pole A × 1
- Pole B × 3
- End Cap × 1
- Silicone Strip Light × 1
- Power Adaptor × 1
- Controller × 1
- Screw × 8
- Screw × 2
- Screw × 1
- Driver × 1
Controller Functions
- On/Off Button
- Brightness Control
- Music Mode
- Click once: Switching scenes
- Hold: Color loop
Installation Steps
- Attach the horizontal stands to the lamp base using screws.
- Assemble the poles (Pole A and Pole B sections) by screwing them together.
- Insert the assembled poles into the lamp base.
- Attach the vertical stand to the top of the assembled poles.
- Connect the silicone strip light to the vertical stand.
- Connect the power adaptor and controller.
- Secure the silicone strip light with screws as indicated in the diagrams.
Placement Options
Vertical Placement
Follow the assembly steps to set up the lamp in a vertical orientation.
Horizontal Placement
- Attach the horizontal stands to the lamp base.
- Assemble the poles.
- Insert the poles into the lamp base.
- Attach the silicone strip light to the poles using the provided screws.
Note:
- To avoid deforming the silicone light strip, press it into place at the top and bottom first, then press the middle.
- Do not cut the light strip to avoid device damages.
